2014 Chevrolet Impala power train problems

“The contact owns a 2014 Chevrolet Impala. While driving at an undisclosed speed, the Stabili-Trak warning light illuminated and the vehicle lost power steering functionality, causing the steering to become extremely firm. The contact stated that excessive force was needed to turn the steering wheel. The contact safely pulled over, and after the audible alarm ceased, the vehicle returned to normal operation. Additionally, the vehicle lost electrical power and stalled on several occasions. There was no warning light illuminated. While the vehicle was stationary, the vehicle frequently lost power. The contact stated that the battery terminals were disconnected and reconnected after the failure, and the vehicle operated for approximately 15 minutes before the vehicle stalled again. The manufacturer was notified of the failure. The local dealer had inspected the vehicle and confirmed the failure. The dealer had retrieved several unknown fault codes. The vehicle was not yet diagnosed.”

“The contact owns a 2014 Chevrolet Impala. The contact stated that while driving at an undisclosed speed, the messages "Stabili-trak" and "Power Steering" displayed on the instrument panel, and the traction control warning light illuminated. Additionally, the transmission display switched from drive(D) to park(P) while driving, causing the vehicle to decelerate and stall. The rear-view camera also intermittently failed to function properly, displaying the message "Park Assist Not Available" while reversing. The contact pulled over, waited, and then restarted the vehicle. The contact stated that the wheel hub, camshaft sensor, and a cylinder had previously been replaced, but the failure persisted. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure. The failure mileage was unknown.”

“The contact owns a 2014 Chevrolet Impala. The contact stated that while driving at an undisclosed speed, the check engine warning light and stabili-trak warning light were illuminated. An Independent mechanic was contacted. The vehicle was taken to an independent mechanic, where it was diagnosed, and determined that the transmission needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 14V092000 (POWER TRAIN); however, the VIN was not included in the recall. The manufacturer was notified of the failure and informed the contact that the VIN was not included in the recall. The failure mileage was 125,000.”

“I have push to start car. On my lunch i starting my car and I immediately notice the rpm went to 2500, which is high and it went up to 3000 and then the warning light flashed stability track error and check engine and swerving light I took a pic. I turn car off and wait a few min turned car back on and it was fine. No errors drove to get lunch and back no issues. Then on leaving work s ame thing happened but the error didn't go away. I was able to shift out of gear. Hard knocking, gear shifter light all white no clue what gear it was in I moved to another parking spot but was slow moving very delayed. Parked and now waiting for tow truck”

“The brakes continue to malfunction I am unsure if a previous recall was fixed properly or not the Chasis electrical system has been fixed with electrical tape only the transmission and stability track and anti lock brake system error light with go off from time to time when it does and the more it’s driven the worse the issues get these are all recalls and the problems still persist are we confident that the recalls have been corrected”

“Fourth time I had submitted this text so this one will be vague. I've had to Repair my stuts and shocks and brakes to my vehicle due to ongoing issues with tires while divingand hitting small speesbumps and potholes. I did replace low performance tires and still was an issue with my struts and shocks when I drive causing me to hit a bump or a small hole and diverts me to the next lane of ongoing traffic also I had to my battery replaced twice. To find out that it was only due to corrosion and the battery cables slipping was frustrating cause I did replace the battery and key fob battery already. Car wouldn't start and when it did it took forever hours to restart and engine still seems to get bogged down In ongoing traffic. Which was the prior issue no power no matter how hard i press the gas. I took to autozone and they did a reading which came back that everything was okay including the battery which was obviously not okay. It was leaking fluid and i have already replaced year and half ago due to same issue. They cables seem to slip over time on its own. What to do? Thank you for your time to look into this issue. Kindest Regards”