2010 Chrysler 3 Series electrical system problems

“The contact owns a 2010 Chrysler 300C. While driving at an undisclosed speed and approaching a roundabout, the brake pedal was depressed; however, the vehicle stalled. The vehicle was restarted and driven to the residence. The owner performed a diagnostic test but found a recorded history of the vehicle shutting down in the computer. The vehicle was not repaired, and the failure persisted. The contact referenced NHTSA Campaign Number: 10V200000 (ELECTRICAL SYSTEM); however, the VIN was not included in the recall. The vehicle was taken to a dealer. The manufacturer was notified of the failure. The failure mileage was 99,000.”

“The vehicle was sold with an outdated battery and later experienced repeated breakdowns. During the first repair visit, the dealership replaced the battery and alternator but failed to identify the root cause of the problem. The vehicle was returned, but the next day it broke down again. Upon inspection, it was discovered that the wiring harness was severely burnt and melted, creating a significant safety hazard that could cause stalling, fire, or total electronic failure. The dealership later diagnosed a PCM failure, which was not detected during the first repair visit. The wiring damage and PCM issue were not disclosed to the vehicle owner by the dealership, and there was no explanation provided for the cause. The problem has been confirmed by the dealership during the second visit, and photographs of the wiring damage are available. The electrical system and engine control were compromised, placing the driver and others at risk of sudden vehicle failure while driving.”

“The contact owns a 2010 Chrysler 300. The contact stated while attempting to turn off the vehicle, the vehicle remained powered on without the key in the ignition. The vehicle was taken to a local dealer where it was diagnosed with needing the WIN module replaced however, the vehicle was not repaired. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 10V200000 (Electrical System) however, the VIN was not included. The manufacturer was informed of the failure and informed the contact that the VIN was not under recall. The failure mileage was 124,725.”

“On May 9th I went to pick up my check and I freaking ran over run over a big rock in the street and it it put like a little hole in my oil pan well this is my first car I've had already my second car I haven't had it for that long so what I did was I'm going to try to get home as the oil slowly leaking out but I was going to try to get home and I drive for like for like 3 minutes at like 20 at like 25 miles per hour 30 miles per hour and like probably like three or four minutes from that incident and I stopped before that too to get the money and then I tried to raise home whatever I'm driving and in the key pops out the addition but it always pops out the ignition crazy and s*** but then the car just like like the lights just act like they they just died on me while I was driving he pops out the lights or whatever and then I stayed that day with my car that happened at 5:00 I was trying to patch up the oil coming out and it turned out to be 2:00 when I noticed it was 2:00 and the oil still coming out all this extra s*** I was probably 1:00 and I bought a oil I bought a one thing oil just to keep keep it in there and stuff cuz I thought I lightweight patched up…”

“2 ISSUES: 1)WHILE DRIVING, VEHICLE FREQUENTLY SHOWS NO AIR PRESSURE IN FRONT DRIVER SIDE TIRE SENSOR, HAPPENS FREQUENTLY 2) WHILE STARTING, VEHICLE WILL START AND RUN FOR APPROX 2-3 SECONDS THEN ENGINE WILL SHUT OFF, ISSUE 2 TYPICALLY DOES NOT REPEAT AFTER TURNING OFF VEHICLE THEN RESTARTING. THIS ISSUE OCCURRED MORE OFTEN WHEN STARTING VEHICLE AFTER BEING BRIEFLY TURNED OFF”

“LOW OIL PRESSURES LITE COMES ON BLINKS GOES OUT WHEN YOU PRESS DOWN ON THE PEDDLE TO ACCELERATE CAR REPLACED OIL SENDING UNIT STILL DOES IT HAS TO BE ELECTRICAL PROBLEM CAR 10 YEARS OLD”