2013 Chrysler 3 Series power train problems

“The contact owns a 2013 Chrysler 300. The contact stated that driving on multiple occasions while driving at various speeds, the infotainment panel went black and did not work as intended. Additionally, the contact stated that the message “Wrong Gear/Change Gear” was displayed. The contact stated that several unknown warning lights were illuminated. The contact stated that on another occasion while in neutral, the vehicle failed to shift into park as intended. The vehicle was taken to a dealer twice however, the failure was not duplicated. The vehicle was not repaired. The contact stated that years later, the vehicle was taken to an independent mechanic where it was diagnosed that the infotainment system needed to be replaced. The failure persisted. The manufacturer was not notified of the failure. The failure mileage was approximately 8,000.”

“The timing chain guides broke under 100,000 miles just look a recall notice given to many that the same motor and vehicle had the same year. Notice states q1 2013 with the 5.7 mds motor and this motor has all the labels amd original. Car almost cause a pile up on i-20”

“RECENTLY PURCHASED A 2013 CHRYSLER 300 THE VEHICLE HAS BEEN HAVING CONSTANT STARTING ISSUES. I HAVE TAKEN THE VEHICLE TO AT LEAST 5 SHOPS AND EVERY SHOP IS TELLING ME THAT MY VEHICLE IS HAVING CODES COME BACK FOR THE AUTOMATIC TRANSMISSION: CONTROL MODULE (TCM, PCM) THE CAR HAS BEEN WORKED ON MULTIPLE TIMES AND I AM STILL UNABLE TO FIX THE PROBLEM. I SEEN THERE IS A RECALL FOR 2013 CHRYSLER 300 FOR THIS EXACT ISSUE AND I BELIEVE MY VEHICLE MAY HAVE BEEN AFFECTED.”

“HANDS FREE MODULE QUIT WORKING, COMMON PROBLEM WITH DODGE/CHRYSLER, AC WILL NOT RECIRCULATE CAUSES ONLY OUTSIDE AIR TO BE DRAWN INTO THE CAB, CAUSE IS MALFUNCTIONING/BAD HUMIDITY SENSOR ABOUT THE RESR VIEW MIRROR, DRIVER HEATED SEAT QUIT WORKING, LEFT HEADLIGHT QUIT WORKING, BAD HID BALLAST. THE GAS AND BRAKE PEDAL ASSEMBLY WILL RETRACT ON IT'S OWN WHILE DRIVING. THE TRANSMISSION W5A580-NAG1-722.6 EITHER SHIFT EXTREMELY HARD 3-4 4-5 OR SLIPS IN BETWEEN THE GEARS CAUSING THE ENGINE RPMS TO GO WAY UP AND THEN EITHER FALLS BACK INTO GEAR OR CAUSES A NEUTRAL AND WILL NOT GO BACK INTO GEAR UNTIL YOU EITHER DROP BELOW 18 MPH OR COMPLETELY STOP AND EITHER PUT THE CAR IN PARK AND BACK INTO DRIVE OR SHUT THE ENGINE OFF FOR ABOUT 10 SECONDS AND START IT BACK UP. AFTER THE FLARE BETWEEN GEARS IT IS STUCK IN 3RD GEAR OR LIMP MODE WITH A CHECK ENGINE LIGHT DTC READ P0730 THROUGH P0735. LITERALLY HAVE TO CARRY A DIAGNOSTIC SCAN TOOL WITH ME TO CLEAR THE CODES. ITS EXTREMELY DANGEROUS AND ALWAYS HAPPENS IN THE WORST PLACES LIKE GETTING ON THE INTERSTATE OR ON BUSY CITY STREETS ALMOST CAUSES AN ACCIDENT BECAUSE YOU HAVE NO CHOICE BUT TO PULL OVER AND STOP NO MATTER WHERE YOU…”

“TL* THE CONTACT OWNS A 2013 CHRYSLER 300. THE CONTACT STATED THAT UPON PURCHASE OF THE VEHICLE, THE VEHICLE WOULD SHIFT OUT OF GEAR INDEPENDENTLY WITHOUT WARNING. THE CONTACT HAD TAKEN THE VEHICLE TO MCCLUSKEY CHEVROLET (9673 KINGS AUTO MALL RD, CINCINNATI, OH 45249) ON TWO SEPARATE OCCASIONS WHERE THE MECHANIC WAS UNABLE TO DETERMINE THE CAUSE FOR THE FAILURE. THE CONTACT STATED WHILE AT A COMPLETE STOP, THE VEHICLE STALLED WITHOUT WARNING WHILE DEPRESSING THE ACCELERATOR PEDAL. THE CONTACT WAS UNABLE TO RESTART THE VEHICLE. THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC WHERE THEY DIAGNOSED THE VEHICLE WITH TRANSMISSION FAILURE. THE MANUFACTURER HAD YET TO BE NOTIFIED OF THE FAILURE. THE VEHICLE HAD YET TO BE REPAIRED. THE FAILURE MILEAGE WAS UNKNOWN.”

“TL* THE CONTACT OWNS A 2013 CHRYSLER 300. THE CONTACT STATED WHILE DRIVING ON CRUISE CONTROL AT 70 MPH, THE VEHICLE SHIFTED INTO LIMP MODE. THE VEHICLE WAS SHIFTED FROM AUTOMATIC TO MANUAL MODE HOWEVER, THE VEHICLE INDEPENDENTLY ACCELERATED TO 80 MPH WITH THE CHECK ENGINE WARNING LIGHT ILLUMINATED. THE CONTACT STATED THAT THE FAILURE RECURRED THREE TIMES. THE VEHICLE WAS TAKEN TO NEW CARLISLE CHRYSLER JEEP DODGE RAM - TOBEY AUTO GROUP LOCATED AT (580 N MAIN ST, NEW CARLISLE, OH 45344) TO BE DIAGNOSED. THE DIAGNOSIS WAS THAT THE TORQUE CONVERTER WAS DIRTY AND THAT A FAULT CODE WAS NOT RETRIEVED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 41,000.”