2000 Chrysler Sebring seat belts problems

“SEATBELT LOCKS UP TO WHERE U CAN'T PUT IT ON BEFORE DRIVING OR WHEN DRIVING AND SEATBELT IS ON IT SOMETIMES LOCKS UP AND YOU CAN'T MOVE YOUR LOCKED IN PLACE WHILE DRIVING. WHILE DRIVING IF IT LOCKS UP IT CAN HAPPEN ANYWHERE ON ANY ROAD OR FREEWAY IT'S MALFUNCTIONING AND IT'S ANNOYING ESPECIALLY WHEN U HAVE TO BE SOMEWHERE AND YOU CAN'T GET YOUR SEATBELT TO WORK MAKING ME DRIVE WITHOUT IT ON.. SINCE I BOUGHT THE CAR 4 YEARS AGO IT'S BEEN DOING THIS”

“DRIVERS INBOARD SEAT BELT BROKE OFF WHEN MY SON TRIED TO BUCKLE UP IN THE DRIVEWAY. POTENTIALLY A FATAL SITUATION IN AN ACCIDENT. THE CONNECTING CABLE FRAYED. IT WOULD NOT HAVE HELD IN ANY TYPE OF FORWARD ACCIDENT.”

“ALL SEATBELTS IN THE CAR HAVE STOPPED FUNCTIONING. IT STARTED WITH THE BELTS RANDOMLY LOCKING, WHETHER DRIVING OR NOT. NOW, I HAVE TO KEEP CLIPS ON THE BELTS TO PREVENT THEM FROM FULLY RETRACTING. *JS”

“ON 6/18/13, I NOTICED THAT THE DRIVER'S SEAT LATCH (THE RECEPTACLE PORTION) WAS BEING PUSHED BETWEEN THE SEAT AND THE CENTER CONSOLE WHEN I ATTEMPTED TO BUCKLE. THE FOURTH OR FIFTH TIME IT DID THIS, THE ENTIRE BUCKLE BROKE OFF. UPON INSPECTION, THE WIRE CABLE CONNECTING THE SEAT BELT LATCH AND THE ANCHOR HAD BROKEN. THE ANCHOR WAS STILL SECURELY BOLTED TO THE SEAT. I HAVE CONTACTED A DEALER AND CHRYSLER, TO NO AVAIL. *TR”

“THE FOLLOWING PROBLEM CONCERNS THE SEATBELT RESTRAINT SYSTEM ".THE SEATBELT CONTROL MODULE" HAS FAILED ON OUR 2000 CHRYSLER SEBRING 1. THIS VEHICLE IS NOT DRIVEN ON A REGULAR BASIS AND AFTER SETTING FOR A PERIOD OF TIME THE BATTERY WAS LOW REQUIRING JUMP STARTING. 2. TWO DEALERSHIPS CHECKED OUT WHAT WAS DRAINING THE BATTERY AND WAS TOLD THERE WAS NO PROBLEMS WITH THE CAR. 3. WITH THE BATTERY GROUND DISCONNECTED AND AN AMMETER BETWEEN BATTERY GROUND AND CHASIS GROUND MY INITIAL READING WAS .06 AMPS,. 4. WITH THIS SAME TEST SETUP IN PLACE THE DOORS WERE OPENED AND THEN CLOSED THE AMMETER READ .5 AMPS DRAW ON THE BATTERY AFTER THE CONTROL FOR THE INTERIOR LIGHTS TIMED OUT. NOTE:THE INITIAL BREAKING OF THE GROUND DISGUISED THE PROBLEM. (MAYBE WHY DEALERSHIPS DID NOT DETECT THE PROBLEM) . I PROCEEDED TO PULL FUSES UNTIL I DISCOVERED THE .5 AMP DRAIN WENT AWAY WHEN THE FUSE FEEDING THE SEAT BELT CONTROL MODULE WAS PULLED. I HAVE NOT YET HAD OUR CAR REPAIRED HOWEVER APPEARANCES ARE THAT THE MODULE IS DEFECTIVE. THIS PROBLEM MAY NEVER HAVE SHOWED UP HAD THE CAR BEEN DRIVEN ON A REGULAR BASIS KEEPING THE BATTERY FROM GETTING TOO LOW TO START THE CAR. EVEN WITH THE FUSE…”

“TL* THE CONTACT OWNS A 2000 CHRYSLER SEBRING CONVERTIBLE. THE CONTACT STATED THAT THE DRIVER AND PASSENGER SIDE SEAT BELTS WERE LOCKED AND WOULD NOT RETRACT. THE VEHICLE WAS NOT TAKEN TO THE DEALER. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS 154,000 AND THE CURRENT MILEAGE WAS 157,000.”