2018 Dodge Durango engine problems

“Back to back error codes P0300 P0108 P1404 P0172 Rough running engine. Very strong smell of fuel at two different times while driving. Vehicle not responding to gas pedal while driving on highway. Repairs at thousands of dollars.”

“The contact owns a 2018 Dodge Durango. The contact stated that the check engine warning light was illuminated. The vehicle was taken to a certified mechanic, who diagnosed that the spark plugs had failed and needed to be replaced. The vehicle was repaired; however, a week later, while the vehicle was idling, it was vibrating abnormally. The vehicle was taken to the same mechanic who diagnosed the vehicle and determined that the cam lobes were worn and needed to be replaced. The mechanic confirmed the findings with the dealer, and it was confirmed that it was a known issue due to the heat treatment to harden the steel not being properly performed. The vehicle was not repaired. The manufacturer was informed of the failure and confirmed that the vehicle was not covered under recall or warranty. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 66,700.”

“Over time, the valvetrain in my engine became gradually louder. Because there were no check engine lights or fault codes, I initially assumed this was a normal characteristic of the engine. That changed on January 2, 2026, when I began to hear a pronounced knocking/loud tapping noise accompanied by a cylinder 8 misfire. At that point, I stopped driving the vehicle and had it towed to a repair shop. Based on the symptoms, we initially believed the issue would be limited to a camshaft and lifter replacement. However, after draining the oil and cutting open the oil filter, a significant amount of metal debris was discovered. Further inspection revealed that one camshaft lobe had been worn down nearly smooth and the corresponding lifter had failed. When the camshaft was removed for full evaluation, all other lobes showed normal, even wear. Only the lobe associated with the failed lifter exhibited catastrophic damage beyond repair. As a result of the metal contamination throughout the engine, a full engine replacement was required rather than a repair of individual components. The basis of my complaint is that this failure appears to be a well-documented and common…”

“While driving on the Thruway, the vehicle tends to misfire which results in lost power to the engine and shaking of the vehicle. The check engine light starts flashing and it becomes unsafe to maintain speeds. The issue was diagnosed as Cylinder 5 Misfire caused by camshaft and lifter failure. This sudden loss of power while driving at highway speeds could cause an accident if it happens during traffic or passing situations. This is a known issue with the 2018 Dodge Durango GT V6 and should be a recall on the vehicle. This is a major engine issue.”

“My vehicle began to misfire after driving roughly 8 miles, check engine light would flash and ding. After shutting vehicle off for a while and restarting it, problem would be gone until driving approximately 8 miles. Brought to Chrysler service center, where they reproduced the problem and determined it is a camshaft or camshaft related issue. Vehicle is parked at that service center awaiting parts that are backordered until January. Vehicle cannot be driven in this condition. If the camshaft fails catastrophically, it could destroy the entire engine, putting myself and whoever else is in the vehicle in danger.”

“3.6L V6 Engine, Auto Start/Stop light came on followed by check engine light. Codes for multiple misfires, replaced multiple coils and replaced all spark plugs. After all was replaced, still had the same issues. Took it to a local Dodge dealership and they said it was a head gasket but it would have to be sent off to figure out which one.”