2010 Dodge Ram 1500 power train problems

“The contact owns a 2010 Dodge Ram 1500. The contact stated while driving at an undisclosed speed, the driveshaft detached. No warning lights were illuminated. The contact received notification for NHTSA Campaign Number: 13V038000 (Power Train) however, the part to complete the recall repair was not yet available. The vehicle was towed to a dealer, where it was diagnosed that the rear axle pinion nut needed to be replaced. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 262,420.”

“During unrelated work, a mechanic discovered the retaining ring for recall N08 (rear axle pinion nut) was not installed and the pinion nut was loose enough to turn by hand. He stated the recall had either been performed incorrectly or not at all, and that the vehicle was unsafe to drive. The recall shows “completed” in 2013, but the defect is still present. I contacted Stellantis Customer Care, submitted photos, and they confirmed in writing that if the defect still exists, the recall must be performed free of charge regardless of age, mileage, or ownership. I sent the photos of the missing ring, screenshots showing the recall marked completed, and Stellantis’ confirmation to the dealership before having the vehicle towed to verify coverage. The truck was towed to Time Chrysler Dodge Jeep Ram of Portland. My initial contact was [XXX] at that location. However, all recall decisions and communication later came from [XXX] , who works at a different dealership. Over the next month, the dealership repeatedly stalled the recall, saying they were waiting on approval from the district manager and then from the recall department, but no action was ever taken. Despite…”

“2010 Dodge Ram 1500 truck purchased used late May 2025 with 57000 miles. Late August 2025 with 60000 miles rear axle fell off when driving on Freeway at 60 miles per hour. Very serious accident was narrowly avoided as could not steer vehicle.Truck was serviced at dealership for recall of a pinion nut coming loose at 36107 miles in September 2013. Per this recall, the loose pinion nut can cause the axle to fail. The recall maintenance done in September 2013 at 36107 miles only lasted 24000 miles and serious safety issues reoccurred. In my opinion, on my vehicle the recall did not fix the problem. Now I am stuck with a $5000 repair on a vehicle with known recalls and safety issues that was supposedly fixed.Perhaps a second recall should be considered regarding this issue.”

“Me and my husband were driving down the road to go see a friend and all of a sudden the wheel hub assembly broke in half causing us to have to slam on our brakes and keep from crashing. The wheel almost ended up under our truck making the truck look like it was kachowing like Lightening McQueen from the movie Cars”

“I was driving to work on [XXX] when my rear end locked up and I slid sideways down [XXX]. I was going slower than normal due to slippery road conditions. The mechanic told me it was the pinion nut that froze up and locked up the gears and snapped the drive shaft. If it had been clear roads the truck probably would have flipped over.”

“The contact owns a 2010 Dodge Ram 1500. The contact stated while driving at an undisclosed speed, there was an abnormally loud sound coming from the rear of the vehicle. The vehicle was taken to an independent mechanic, where it was diagnosed and determined that the rear axle differential pin retaining bolt had failed and needed to be replaced. The vehicle was not repaired. The vehicle was taken to the dealer but was not yet diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 160,704.”