2012 Ford Fusion steering problems

“The contact owns a 2012 Ford Fusion. The contact stated that while entering the vehicle to start the engine, the power steering became inoperable. The contact associated the failure with NHTSA Campaign Number: 15V340000 (Steering); however, the dealer refused to perform the steering gear recall repair because no Diagnostic Trouble Codes (DTCs) were present. The contact stated that the dealer was withholding Diagnostic Trouble Code (DTC) information to avoid replacing the steering gear. The manufacturer was notified of the failure by telephone. The failure mileage was approximately 120,000.”

“Our 2012 Fusion suffered a sudden loss of power steering, was diagnosed with code U3000 at a Ford dealer, and that the dealer confirmed it matches the 15S18 recall symptoms despite being built two months outside the window. Our vehicle was manufactured at the Hermosillo plant in 2012, just two months outside the 15S18 recall window. It suffered an identical, sudden loss of power steering assist while driving, indicating Ford's recall parameters failed to capture all vehicles fitted with the defective component.”

“The contact owns a 2012 Ford Fusion. The contact stated that while driving 50 MPH, the vehicle lost power steering assist, causing the steering wheel to be significantly difficult to turn. The contact was able to drive to the nearby residence and parked in the driveway. The message "Service Power Steering Assist" was displayed after the failure. The contact associated the failure with NHTSA Campaign Number: 15V340000 (Steering). The failure mileage was approximately 98,000.”

“While I was driving my 2012 Ford Fusion on August 3rd the steering cut out. I parked the car and re-started it and it worked again. It went to the shop (Extra Mile Automotive) on XXX where they informed me of the 2015 recall on the steering. Recall number 15S18 and program 15N01 When I spoke with [XXX] Ford in [XXX], they said they replaced the electrical piece of the recall on December 7th 2015, but not the steering shaft. [XXX] (the westlie ford employee) said because the electrical was completed, the recall procedure was marked as completed, even though [XXX] said that this is very much tied to the original recall. I asked him to submit a Special Service Support Center request to get this fixed and he did submit that on XXX. On XXX it was denied. On XXX I also requested to speak to [XXX] supervisor and was connected to [XXX] (id # XXX) who also said there was nothing she could do because this was already "solved" in 2015. This is not a new or unrelated repair request, it is the unresolved second half of a federally mandated safety recall. Ford's own dealership confirmed that my steering gear failure is directly connected to the original defect covered under…”

“Vehicle experienced loss of power steering so it was hard to steer.When I called a ford dealership I was told my vehicle didn’t qualify for any power steering recalls so I would have to pay full price which is unaffordable”

“I am submitting this formal complaint against Ford Motor Company and its authorized dealership network for falsely reporting a safety recall repair as "resolved" while applying an unauthorized, temporary workaround that left the primary safety defect active. In 2023, I brought my vehicle to an authorized Ford dealership to perform mandatory safety recall service regarding the Electric Power Assist Steering (EPAS) failure. The dealership subsequently updated Ford’s central database (OASIS) to show that the safety recall was fully resolved and completed for my VIN. However, the official Repair Order / Invoice provided to me by the technician explicitly documents that a permanent remedy was not performed due to a lack of replacement parts. The technician’s exact written notes state: "Customer states power steering is not working. Tech and advised verified concern finding that the ground wire pin on the high current wiring harness to PSCM had backed out of the connector. Reconnected pin and cleared codes finding issue resolved. Issue will continue to happen until the harness is replaced. Harness is unavailable at this time. Glued pin into connectors."Because the…”