2013 Ford Fusion fuel/propulsion system problems

“My 2013 Ford Fusion equipped with the 1.6L EcoBoost engine started blowing thick white smoke (Burning Coolant) while I was driving on the freeway. Engine coolant was leaking and my card died right there, that had blown the head gasket. I received no warning, no message. This was an incredibly dangerous situation because I was on the freeway and was forced to stop immediately. Ford Motor Company has refused to include my vehicle’s VIN in the applicable recall programs despite my vehicle experiencing the same issues described in NHTSA recalls 12V551000 (Ford Campaign 12S41) and 17V209 (Ford Campaign 17S09) The recalls identify issues involving coolant loss, overheating, insufficient warning of coolant loss, potential engine damage, cylinder head damage, and the risk of engine compartment fire. My vehicle exhibited these same symptoms and consequences which can be confirmed by the autobody shop where it was evaluated. The purpose of these recalls was to address a known safety concern involving the 1.6L EcoBoost engine cooling system. Despite this, when I contacted Ford and requested assistance and asked that my VIN be added to the recall population, Ford denied my…”

“Vehicle makes strange sounds from the fuel fill inlet and proceeds to stall shortly after while driving and most of the times fails to restart based on my own research it looks like purge valve issues My safety was put at risk by almost being rear ended multiple times from stalling on the expressway and red lights The problem has not been reproduced yet by the dealer it will be looked at on 07/15/26 The component has not been inspected yet The check engine light illuminated when the issue started”

“1. After vehicle is given gas it won’t crank. 2. Tire sensors won’t turn off. Even with brand new tires and mounts. 3. Random electrical malfunctions. (Flickering dash lights, delayed engine start after turning the key, light bouncing back and forth between gears, etc.)”

“I had coolant leaking in my 2013 Ford Fusion SE 1.6L causing a misfire in cylinder 3 from diagnostics code P0303. After going to a repair shop on 3 seperate occasions and paying to fix issues thought to remedy the issue, I had the Ford dealership in Hudson WI look at it while they took care of a recall. They quoted me $9,900 to replace the engine due to a cracked block. It was hard to get a response from the technician and they were really unprofessional towards me when I requested the part numbers. So much time has been spent on this not to mention that I have been without a vehicle for 1.5 years because my inability to cover additional repairs or the cost of a new car. I also lost my job due to my transportation issues, and paid over $19,000 for this vehicle. I wish Ford would issue a recall because this is a very common issue for this make and model. 2013 Ford Fusion SE L4 1.6L (102K miles)”

“Two recalls for this make year and model car had been recalled previously but not for my VIN specifically and the issues are appearing. The first is “doors may open driving” recall on your website and the second is “engine cylinder head may leaks oil” which is also on ur website. Both were recalled for this make and year of the ford fusion but not for my VIN so ford is stating they cannot fix it and want to charge me even for a diagnostic.”

“The purge valve is likely malfunctioning, which affects the fuel system. Yes, it is available for inspection upon request. The malfunction caused the vehicle not to start after pumping gas, potentially leaving me stranded in unsafe locations, which could be hazardous, especially in high-traffic areas or remote locations. The issue has not yet been officially reproduced or confirmed by a dealer or independent service center. No, the vehicle or component has not been inspected by the manufacturer, police, or insurance representatives. There were no warning lamps or messages before the failure. The issue first appeared when the vehicle failed to start immediately after refueling.”