2018 Ford Fusion engine problems

“The contact owns a 2018 Ford Fusion. The contact stated that there was an abnormal sound coming from the rear of the vehicle. In addition, the engine made a bubbling sound after turning off the vehicle. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, where an engine misfire was diagnosed, and a fuel odor was detected. The mechanic determined that the engine had failed and needed to be replaced. The failure mileage was approximately 138,000.”

“My 2018 Ford Fusion suffered a sudden and complete engine failure caused by internal coolant intrusion — coolant leaking into the cylinders and destroying the engine. Pep Boys diagnosed that the failure developed internally over time and could not have been avoided by the owner. This is a known Ford factory defect in the 2.0L EcoBoost engine, documented in Ford's own publications (SSM 47204, SSM 47462, TSB 19-2346, TSB 22-2229), all of which cover the 2018 Fusion. The root cause is Ford's open-deck engine-block design, which allows coolant intrusion and cracking between cylinders. Ford corrected the design in 2019 production. A federal class action (Nelson et al. v. Ford, E.D. California) and NHTSA defect petition DP26008 concern this same defect. The sudden loss of engine power created an unsafe driving condition. My warranty claim was denied based on a 'blown head gasket' finding, which is the symptom of the factory defect, not the cause.”

“Capital Ford of Wilmington diagnosed my vehicle with coolant intrusion into cylinder 2, accompanied by diagnostic trouble codes P0302 and P0316, after check engine light came on. I have been advised that the vehicle requires a complete engine replacement, with an estimated cost of $13,180.89. The vehicle has experienced sputtering and hesitation, creating concern that it could lose power or stall. These symptoms are concerning. After researching this issue, I have learned that coolant intrusion is a documented problem associated with certain Ford vehicles equipped with the 1.5L EcoBoost engine produced during the 2017–2019 period. Ford has addressed this issue through Technical Service Bulletins and Customer Satisfaction Program 21N12. I contacted Ford and was told that my VIN is not covered under the Customer Satisfaction Program. When asked why mine was not covered but other were , Ford stated that even if it is the same issue that is being recalled if my VIN is not flagged it will not be covered for any recall or assistance.I called Ford when I first purchase vehicle and asked about this recall and was told if I didn't have anything wrong with my car and no…”

“My 2018 Ford Fusion Titanium FWD (VIN: [XXX]) suffered a catastrophic engine failure while driving, causing sudden vehicle overheating, severe engine misfires, and a dangerous loss of power on the roadway.A certified Ford dealership inspection (Invoice #XXX) confirmed that the vehicle has a textbook manufacturing flaw known as EcoBoost coolant intrusion. A pressure test showed an immediate 5 PSI drop within 10 minutes, and a borescope confirmed that engine coolant is actively leaking across the block interface and pooling directly inside the engine cylinders (cylinders 2 and 3).This is a known, widespread structural engineering defect in Ford's block casting that creates a severe, sudden safety hazard by causing vehicle stalling and clouding exhaust smoke while operating at highway speeds. The vehicle is now entirely unsafe to drive and requires a full engine block replacement.”

“My engine coolant keeps on overheating, I’ve tried changing the antifreeze tank out for a brand new one and it helped the issue for a while but I have to relieve the pressure myself which is a hazard. I’ve had to change the coolant in the tank more than 5 times and it just seems like it’s leaking somewhere other than going into the engine to cool it. When I go out roundabouts off a highway the engine overheats and makes the car go into a safe mode where it won’t go and I have to stop on the side of the road. When I’m driving with my heat on the heat will go cold when I slow down. If I’m not going over 3x1,000 RPMs it will go cold and fluctuate. This has been going on for months now.”

“We have coolant intrusion in cylinder 2 of our engine. This can cause highway failure of engine cuts out, car runs rough and it can become a fire hazard. We paid for a diagnostics through a ford dealer. Who we uses all the time for our warranty needs. We noticed car was starting to run rough and check engine light came on 8/5/26”