2015 Ford Mustang exterior lighting problems

“The contact owns a 2015 Ford Mustang. The contact stated that before making a left turn the contact switched on the left turn light signal; however, upon making the left turn the contact noticed that the left turn signal on the instrument panel was flashing twice as fast as normal. The contact pulled over to inspect the vehicle. The contact became aware that the taillights were inoperable; however, after restarting the vehicle, the taillights became operable. The following day the contact drove to a local dealer where the vehicle was inspected; however, the vehicle was not diagnosed. The contact was informed that the vehicle needed to be diagnosed to determine the cause of the failure. The contact was made aware of SSM: 10144218 and linked it to the failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 82,000.”

“There is a break pedal pad that is broken. It doesn't allow the car to accelerate correctly and car goes in limp mode. All break lights are illuminated when car is turned off. There is a recall for this, but I purchased my car in CA. I think the car was originally a Nevada car. Am I still eligible for the recall even if I didn't get the notification and my state of purchase was not mentioned?”

“The brake pedal stop bumper in my car disintegrated in the middle of the day and fell off. The brake lights do not turn off anymore and the vehicle can be started and shifted without needing to press the brake. I found a recall # 22S02 for this exact issue but my vehicle is not covered by it (assuming due to region). The vehicle has not been inspected yet.”

“A plastic clip ("Brake Pedal Bumper") broke and fell out of place, causing the brake pedal to no longer reach the brake light switch. The brake lights now remain illuminated permanently, even with the brakes released. This also caused the engine and transmission to go into "limp mode", the engine no longer revving over 2,000 RPM, the transmission not shifting, and hill-start assist and traction control no longer working, making the car unsafe to drive. The brake lights will remain on even when the car is completely shut off and locked, draining and damaging the battery. It is my understanding that this is a known issue, and there was a recall for this in certain states. (Safety Recall 22S02, Regional Recall 22R01). There should be a national recall for this, as the affected part appears to be of low quality, and causes safety issues when it fails, with the car's drivability and lighting affected.”

“Third tail light and rear tail lights remained illuminated after the car was turned off. Driver discovered the brake light switch (rubber/plastic piece) had crumbled into the floor board preventing the tail lights from turning off, thus, becoming a hazard to other motorists on the road as the tail lights remained illuminated even while driving. While the vehicle was being driven, the driver could not accelerate to the appropriate speeds as the car was "thinking" the brakes were being applied and could only approximately drive at 40-50 MPH. The vehicle has been inspected and the above information was confirmed as the issue. No other warnings/messages occurred prior to the piece breaking.”

“My break light switch pad is broken and is causing the car to not maintain speed and sluggish acceleration. I have seen other drivers report the same failure with their cars.”