2021 GMC Yukon fuel/propulsion system problems

“While stopped in a parking lot. I returned my vehicle to drive home, and the car would not start. I had it towed to the dealer. They did a diagnostic inspection for "crank-no-start ". Two trouble codes: P0340 intake single camshaft ignition sensor circuit and P00C6- fuel rail pressure load during engine cranking. Performed diagnostic checks and suspect a broken timing chain and timing tensioner that causes the bottom of the engine to free spin while the top 0.5 does not. These engines are known as interference engines, and anytime there is a mismatch between the top 0.5 and the bottom 0.5, there is the potential for catastrophic failure due to the design of the valve train and bottom 0.5 of the engine. The technician suggested a full engine replacement. I went to the dealer and spoke with the Service Manager, Greg, and he stated that he would reach out to GMC because the VIN number was not part of the recall, although the YEAR/MAKE/MODEL is. I also reached out to GMC to open a claim. To date, I have not heard back, and they have not yet accepted responsibility for replacing the engine.”

“My 2021 GMC Yukon has approximately 36,900 miles. On September 12, 2026, the vehicle was at an authorized GMC dealership and passed a state safety inspection. On September 19, 2026, the check-engine warning light illuminated and I returned to the dealership. The dealer performed diagnostic testing and told me the fuel pump pressure was approximately 400 PSI when it should be approximately 700 PSI. I was told the fuel pump needs to be replaced. The vehicle is currently at the dealership awaiting the replacement part: Fuel pump I was not aware of a fuel-pump failure before the warning light appeared. I am particularly concerned because this failure occurred at only approximately 36,900 miles. GM previously recalled 3,386 2021 GMC Yukons under NHTSA Campaign 21V-739/GM Recall N212332040 for a fuel-pump power-control-module defect that can cause the fuel pump to fail or operate intermittently, interrupt fuel flow and potentially cause the engine to stall. My 2021 Yukon is not included in that recall and currently shows no unrepaired recalls associated with my VIN. I believe this represents a potential safety concern because inadequate fuel delivery or a fuel-system…”

“Took car in to have it checked for recall on engine and have oil changed to new standards with WD40 was told the engine and car was fine “just use this new oil” A MONTH later was driving and engine would not shift come to find out our transmission was going out it was replaced thanks to our extended warranty (even tho it only had 98,000 miles on it) a week after a fuel pump was out and we had to pay to replace it. There were never check engine signs and no signs of the car having failure truly it ran great until the new oil.”

“1. What component or system failed or malfunctioned. The Fuel Pump Module failed unexpectedly while the vehicle was being driven. Failure caused the engine to stall, resulting in a complete loss of power and mobility. Unsure if part is available for inspection. 2021 GMC Yukon have a recall N252516900, but our VIN is not included in this. Can our VIN be added to this recall please? 2. How was your safety or the safety of others put at risk? The vehicle abruptly stalled while being driven through a parking lot, causing a complete loss of power and leaving the vehicle disabled in an active traffic area. Because the vehicle could not be shifted out of PARK, it became an obstruction, creating a hazard for other drivers navigating the parking lot and increasing the risk of a collision. 3. Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. After the vehicle was towed to a local mechanic on a flatbed truck, the dealer diagnosed and confirmed that the Fuel Pump Module had failed, which caused the vehicle to stall and lose power. 4. Has the vehicle or component been inspected by the manufacturer, police, insurance…”

“I was driving down the highway and all at once a bunch of different lights and emergency warnings started flashing on my dashboard and my car was almost like sputtering like it wasn’t getting the gas it needed or something. You could feel lots of movement right up front and I was forced to pull over and get towed. They said the engine would need to be completely replaced.”

“Seems to be not accelerating properly as if the propulsion is not there. Also, when switching gears it seems as if it is slipping or missing to keep up with the propulsion. Lastly, riding with windows down on the highway alongside the concrete median, I can hear like metal clanking or rubbing against one another. Also, I get an oil change at George Ballas GMC on [XXX] and 3 weeks later truck says change oil soon. AND YES THEY RESET THE OIL LIGHT AND I DROVE IT FOR 3 WEEKS AND THE LIGHT POPPED ON!!!!”