2006 Honda Civic tires problems

“The contact's daughter owns a 2006 Honda Civic equipped with Kumho Tires, Tire Line: Kumho ECSTA XII, Tire Size: 205/55/R16, DOT Number: 15MA0-1AH0-2424. The contact stated that upon inspecting the vehicle, the rear driver’s side tire and the rear passenger’s side tire were bald and had no treadwear. The vehicle was not taken to the dealer or an independent mechanic. The tires were not replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 70,000.”

“PURCHASED 4 GOODYEAR VIVA 2 TIRES, FROM WALMART ON 10/27/2014, FOR THE FIRST FEW MONTHS THEY WERE GREAT. AFTER AWHILE I KEPT NEEDING TO GET THEM REBALANCED DUE TO VIBRATING, THEY STARTED GETTING LOUDER AND LOUDER. HAD TO KEEP GETTING MY CAR ALIGNED EVERY OTHER MONTH. TODAY ON 10/22/2015, DRIVING STRAIGHT ON CRUISE CONTROL AT 70MPH ON INTERSTATE 376, I STARTED HEARING THIS AWFUL NOISE, I THOUGHT IT WAS A WHEEL BEARING THAT KEPT GOING BAD. THEN THE CAR WOULDN'T ACCELERATE, AND I STARTED SMELLING BURNT RUBBER AND SMOKE COMING OUT OF THE BACK. I PULLED OFF THE CLOSET EXIT AND INTO THE CLOSET PARKING LOT, TO FIND THAT THE TIRE HAD BLOWN OUT ON THE SIDE WALL. I WENT TO THE WALMART THAT I PURCHASED THESE TIRES FROM. SINCE I PURCHASED ROAD HAZARD THEY REPLACED THE TIRE AT A PRORATED RATE. BUT THEY DON'T SELL VIVA 2'S ANYMORE, THEY REPLACED IT WITH A VIVA 3. THE OTHER 3 VIVA'S ON THE CAR, ARE NOW WEARING ABNORMAL ON THE SIDEWALL, WALMART INSISTS THAT I CURBED THEM AND THAT WAS THE PROBLEM, WHEN I KNOW I NEVER DID. SO THEY WONT REPLACE THEM UNLESS SOMETHING HAPPENS TO THEM OR THERE IS A RECALL. I EVEN HAD TO CALL CORPORATE TO TRY AND GET THE REPLACED AND THEY DIDNT WANT…”

“TL* THE CONTACT OWNS A 2006 HONDA CIVIC. THE CONTACT TOOK THE VEHICLE TO AN INDEPENDENT MECHANIC FOR A TIRE ROTATION AND ALIGNMENT. THE MAINTENANCE WAS DECLINED DUE TO A FAILURE WITH BOTH REAR TIRES. THE DETAILS WERE NOT PROVIDED TO THE CONTACT. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS NOT AVAILABLE. UPDATED 01/11/2017*CT; SIMILAR COMPLAINTS WERE NOTED NATIONWIDE FOR CIVIC 2006, WRONG PARTS WERE INSTALLED AS OEM IN THE NEW CAR SOLD UPDATED 04/16/18*JB *TR”

“FIRST NIGHT OF SUBZERO TEMPERATURES WE HAVE HAD IN TWENTY YEARS. TIRE POPPED LEAVING TWO HOLES IN THE SIDE WALL. TIRE SAYS ON IT THAT IT IS STEEL BELTED BUT THERE WEREN'T ANY STEEL BELTS VISIBLE. TIRE BRAND NOT LISTED ON TIRE SELECTION PAGE. CHAMPIRO 328 GT RADIAL 205/55 R16 91H DOT 9UH9. *TR”

“WITH MY SEVEN YEAR OLD CAR I HAVE GONE THROUGH NUMEROUS TIRES. ALWAYS REPLACING THEM DUE TO THE ALIGNMENT ON MY CAR WHICH I HAVE BEEN TOLD IS NOTHING THAT CAN BE FIXED. THIS IS WAY BEYOND COSTLY AND I DON'T THINK THAT WE SHOULD HAVE TO KEEP PAYING FOR HONDA'S MISTAKES. I WILL JUST BE DRIVING DOWN THE ROAD THEN RANDOMLY MY TIRES WILL BLOW OUT. SOMETHING NEEDS TO BE DONE ABOUT THIS. *TR”

“I AM ON MY 8TH PAIR OF TIRES WITH MY VEHICLE. MY TIRES WEAR OUT PREMATURELY AND CAUSE HEAVY VIBRATIONS WHILE DRIVING. THE TIRES GET NOTICEABLE FLAT SPOTS ON THEM AND THE TREAD WEARS VERY THIN ON THE INSIDE OF THE TIRES. 2 YEARS AGO WE BECAME EXTREMELY CLOSE TO HAVE ONE TIRE BLOW OUT ON US AS IT WAS WORN ALMOST THROUGH THE ENTIRE TIRE. I BELIEVE THIS IS A VERY DANGEROUS PROBLEM THAT HONDA SHOULD DEAL WITH. THEY HAVE COME OUT WITH A KIT FOR THE REAR UPPER CONTROL ARMS THAT ARE "SUPPOSE" TO FIX THE PROBLEM. I TOOK MY CAR IN TO HAVE THE ARMS REPLACED, FIRST HONDA REGIONAL SERVICE MANAGER SAID THEY WOULD NOT PAY FOR THE REPAIR. SECOND, THEY PUT THE UPGRADED CONTROL ARMS ON THE CAR AND THEY STILL COULDN'T GET THE TIRES ALIGNED PROPERLY, SO THIRDLY I HAVE TO WAIT SO THEY CAN ORDER SOME AFTER-MARKET CONTROL ARMS TO HOPEFULLY FIX THE PROBLEM. YOU CAN PLAINLY SEE WHEN THE CAR IS SITTING ON A FLAT SURFACE THAT THE TIRES ARE SLANTED TOO MUCH. IT IS SO OBVIOUS THAT IF THEY COULDN'T SEE IT AT PRODUCTION, THEY SHOULD THINK ABOUT THEIR HIRING PROCESS. THIS IS DANGEROUS, AND PEOPLE SHOULDN'T HAVE TO PAY FOR PROBLEMS THAT ARE CAUSED BY THE MANUFACTURER. *TR”