2008 Honda CR-V structure problems

“The contact owns a 2008 Honda CR-V. The vehicle was recently taken to a dealer to be repaired under NHTSA Campaign Number: 23V228000 (Structure). The contact stated that the dealer was required to perform a rigorous 7-point safety inspection to ensure the frame was structurally sound for the rear trailing arm reinforcement brace to function properly. However, the dealer overlooked a critical rust hole on the frame by the trailing arm brace. The dealer improperly completed the recall repair despite the structural failure and informed the contact that the recall repair was successfully performed. The contact became aware of the issue after arriving to the residence. The contact believed that the issue posed an immediate safety risk. The vehicle was taken back to the dealer for re-evaluation; however, the dealer refused to provide further assistance. The manufacturer was notified of the structural failure. The failure mileage was 191,000.”

“While driving on October 2, 2026, the driver-side rear trailing arm and subframe mounting structure detached from the frame due to severe corrosion. The vehicle was immediately taken to Brandon Honda (Tampa, FL) for inspection under Safety Recall 23V228000 / Campaign 23-032. Brandon Honda documented on Repair Order #250035 that the "DRIVER REAR SUB-FRAME LOOKS TO BE COMPLETELY DETACHED." However, instead of submitting required inspection failure photos to Honda TechLine for corporate repurchase evaluation as mandated by Service Bulletin 23-032, the dealership issued a $4,222.77 customer-pay body shop estimate from Nu Finish Collision Center (Estimate #046670) to replace the suspension crossmember, trailing arm, and frame rails out of pocket. The vehicle has a completely detached rear trailing arm/subframe, fails the safety recall inspection, and is grounded at the dealership as unsafe to drive. The dealership is refusing to follow official recall failure protocol and attempting to shift financial responsibility onto the consumer for a safety defect covered under federal recall mandates.”

“The contact owns a 2008 Honda CR-V. The contact stated that while driving at an undisclosed speed, the vehicle felt as if it was driving over a bump in the road, causing the steering wheel to be unstable. Upon inspecting the vehicle, the contact became aware that the rear trailing arm was rusted. The contact referenced NHTSA Campaign Number: 23V228000 (Structure); as a possible cause for the failure; however, the recall repair was marked as completed. The dealer determined that the recall repair was not performed. The dealer was notified of the failure, but the vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 202,713.”

“Hello, I have a recall for the corrosion on my Honda CRV 2008, American Honda already has everything on file from the dealer ship I took to get it inspected and is been a whole month and American Honda hasn’t reached out to me. I have been asking American Honda if I could get a loaner car or rental as the service manager at the dealership has said he cannot provide a rental until American Honda authorized since obviously some one has to pay for it. And I’m just reaching out if you guys could help me anyway to help me get this sorted out, dealership has already told me the car is un repairable at this point due to the bad corrosion and American Honda has acknowledged that and said someone from the median department or something like that was gonna reach out to me that was 2 weeks ago and I have reached out a week ago and they said someone would reach out and I have not received anything as I have told them, I really need a car since I recently had my baby and you know I need to come to work and go back home. Please if you guys can help me”

“This is a complaint in reference to a current recall for the rear rust and corrosion issues on Honda CRvs, Part 573 Safety Recall Report 23V-228. I brought my vehicle to Matt Burne Honda on January 7 2025 for this recall and they "inspected" and passed the vehicle, installed the brace, and said all was well as they handed me the keys. In early March I took the car in for its state inspection and it failed due to all of the rust/corrosion/frame rot on the rear of this vehicle. When I called Matt Burne to find out why they installed the brace on this vehicle with all that rust, and why they never even bothered to mention the rust to me, they said that for the recall to pass all they needed to do was remove the bolt for the trailing arm and that all the rust didn't matter, and whether or not it could pass a state inspection didn't matter. This, put me and my family at risk. The rust and corrosion is severe. My family and I have been driving in it thinking it was all okay since the recall was completed. Yet they never thought to mention it. Isn't this recall in reference to rust and corrosion on the rear frame? Yes, I understand it involves the trailing arm, but…”

“The contact’s son owns a 2008 Honda CR-V. The contact stated that while his son was driving 45 MPH, the vehicle aggressively veered over to the right side of the road. The driver inspected the vehicle and noticed that the rear axle had detached from the frame. The driver was able to coast to the side of the road. The vehicle was towed to the dealer who was unable to fix the vehicle under NHTSA Campaign Number: 23V228000 (Structure); because parts were not available, and there were additional damages that needed to be repaired. The manufacturer was made aware of the failure and was working with the dealer to have the vehicle inspected. The failure mileage was unknown. Parts distribution disconnect.”