2010 Honda CR-V structure problems

“The contact owns a 2010 Honda CR-V. The contact stated that there was rust on the rear of the vehicle. The vehicle was towed to the dealer, where it was diagnosed that the rear frame and trailing arm were severely corroded. The contact was informed that the frame could not be repaired or replaced. The contact associated the failure with NHTSA Campaign Number: 23V228000 (Structure). The manufacturer was made aware of the failure by telephone, and a case was opened. The failure mileage was approximately 192,000.”

“The contact owns a 2010 Honda CR-V. The contact stated while the contact's mother was driving at an undisclosed speed, the vehicle was erractically shaking. The vehicle was driven to the contact's mother's residence. The contact's mother contacted an independent mechanic. The vehicle was diagnosed with a corroded trailing arm and rear suspension. The contact was informed that the trailing arm and rear suspension needed to be replaced. The vehicle was not repaired. The contact's mother stated that a recall, NHTSA Campaign Number: 23V228000 (Structure) was performed in September 2023. The dealer was made aware of the failure. The manufacturer was not made aware of the failure. The failure mileage was unknown.”

“The driver’s door lock will not lock or cycles up and down when trying to unlock the door. This is a 2010 Honda CR-V. There is a recall on the same part for the 2007 to 2009 Honda CR-V (Honda Service Bulletin 14-083). The recall needs to be extended to the 2010 Honda CR-V vehicle.”

“The rear passenger-side lower control arm mounting point on my 2010 Honda CR-V has rotted out due to severe corrosion. This has caused a loud clicking noise when driving over uneven surfaces and has compromised the structural integrity of the suspension system. The problem was confirmed by an independent mechanic, who stated that the control arm is no longer properly secured due to rust damage at the mounting point. The vehicle was also inspected by a Honda dealership, which noted frame perforation in and beyond the recall area related to NHTSA Recall No. 23V-228. Despite this, American Honda has refused to address the issue, stating that the corrosion does not fall within the defined recall area. This failure presents a significant safety risk, as the suspension could potentially detach while driving. The issue first became noticeable in mid-March 2025 when the clicking noise started and has persisted since. There were no prior warning lights or error messages. The corrosion is visible and the affected components are available for inspection upon request. The condition has been documented via dealer and mechanic reports, photographs, and video.”

“The contact owns a 2010 Honda CR-V. The contact stated while driving approximately 35 MPH, the stabili-trak warning light illuminated and turned off. The contact stated that there was an abnormal grinding and abnormal rubbing sound coming from the rear of the vehicle while making a left turn. The contact stated that the rear end was swaying to the left and right while attempting to manually correct the vehicle by turning the steering wheel. The contact stopped the vehicle and became aware that the rear passenger’s side tire was leaning at an angle into the wheel well. The vehicle was towed to an independent mechanic where it was diagnosed and determined that the rear suspension had separated from the subframe due to extensive corrosion of the subframe and supports. The vehicle deemed unsafe to be driven by the mechanic. The vehicle was not repaired. The manufacturer was informed of the failure. The contact related the failure to NHTSA Campaign Number: 23V228000 (Structure). The contact stated that the recall repair had been completed in 2023 by a dealer. The contact was referred back to the dealer by the manufacturer. The failure mileage was approximately 190,000.”

“The contact owns a 2010 Honda CR-V. The contact stated that the vehicle was taken to the local dealer to be repaired under NHTSA Campaign Number: 18V661000 (Air Bags), and the dealer informed the contact about NHTSA Campaign Number 23V228000 (Structure). The dealer informed the contact that the vehicle had failed an inspection and was unsafe to drive. The vehicle was not repaired. The manufacturer was contacted and opened a case. The contact stated that a recall notification was mailed and might have been lost in transition, but no additional assistance was provided. The failure mileage was approximately 20,005.”