2024 Hyundai Palisade service brakes problems

“I am reporting a serious potential braking-system safety defect involving my 2024 Hyundai Palisade Night AWD. I experienced steering-wheel vibration when braking and an incident in which the brakes were extremely difficult to apply effectively, leaving me unable to stop in an emergency as needed. This created a serious risk of a collision and injury to me, my passengers, and others on the road. I am concerned that the vehicle’s braking system may not perform reliably when rapid or emergency stopping is required. My vehicle was serviced at Morrie’s 394 Hyundai in St. Louis Park, Minnesota. Following an extended period of recall-related service beginning March 20, 2026, the vehicle was marked ready on July 3, 2026, under Repair Order #[XXX]. I subsequently brought the vehicle back on July 6, 2026, under Repair Order #[XXX], reporting rattling and grinding associated with driving and braking. The dealership documented resurfacing all four brake rotors. I am concerned that the steering-wheel vibration and serious difficulty stopping may indicate a braking problem that requires further investigation. The July service documentation references a “Vehicle Health Report…”

“Car has been shaking & rattling when hitting a pothole and not allowing my car to stop the brakes become very hard to press down on causing my car to move more into the street. I have small children and it is a big safety issues.”

“When stopping on uneven ground ,or steeper down hill the breaks fail to stop. They don’t “catch “ to stop. In separate issue is the “emergency steering” alert flashes on dash randomly and takes over when there is no need to anything out of the normal happening, only happen in very short time maybe under a minute but it shouldn’t come on at all when it does happen”

“The vehicle brakes malfunctioned while driving over bumpy pavement in a parking lot. There was a loss of ability to stop the vehicle, the breaks seemed locked or ineffective. This cause me to come close to rear ending the vehicle in front of me. My foot was pushed FIRMLY on the break and the vehicle seemed to continue to lurch forward. The collision warning alarm was sounding and the brake pedal was vibrating.”

“ABS engaged unexpectedly at low speed, causing the vehicle to shake and fail to stop normally - car was shaking as I came to a stop and stopping distance was longer than normal.”

“While crossing a railroad track, the vehicle in front of me slowed down. I applied the brakes but there was no response. I pushed even harder with excessive force and the brakes did not respond at all. I though for sure I was going to hit the vehicle in front of me when the brakes finally responded. I was traveling at about 20 miles an hour when this incident began. I know there is a recall related to the ABS brakes where a software update is intended. That recall does not indicate a safety hazard. This recall seems related since it appeared to me to be an ABS braking problem. I can tell you that it is certainly a high safety risk. My local dealer can not get me in to address the recalls for another 6 weeks and I'm concerned this may happen again. This needs to be considered a significant safety risk before serious injuries occur. I currently have 20,000 miles on this vehicle. The driving conditions at the time of the incident were dry roads surface, sunny and about 72 degrees F. About 4pm on 6-24-26.”