2016 Jeep Grand Cherokee electrical system problems

“The contact owns a 2016 Jeep Grand Cherokee. The contact stated that while driving 55 MPH, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended with the vehicle shaking erratically. The vehicle was taken to O’Reilly’s where the vehicle was diagnosed with CAM box failure. The contact was informed that the CAM box needed to be replaced. The contact referenced NHTSA Campaign Number: 18V332000 (Electrical System, Vehicle Speed Control); however, the VIN was not associated with the recall. The failure mileage was approximately 170,000.”

“When I push on the gas pedal, sometimes the car revs up and the speed does not increase. I have to shut the car down and then restart. When I restart it, then it resets it in a way and I am able to drive. There is a hyperbola symbol that is seen on my dashboard that blinks when this happens. Please help.”

“Vehicle will stall while driving. Has happened 15+ times when trying to accelerate from a stop light, twice while driving at 45+ mph. Engine will stall and the dash will say "Shift to park to continue driving." Vehicle must be shifted in to park, and then the start button must be pressed to restart the engine and continue driving.”

“The contact owns a 2016 Jeep Grand Cherokee. The contact stated that the A/C system was inoperable. The vehicle was taken to an independent mechanic, where it was diagnosed that the blower motor fuse was burned, melted, and needed to be replaced. The vehicle was repaired; however, the failure recurred several times. The mechanic replaced the blower motor fuse several times; however, the failure persisted. The vehicle was not repaired. The dealer and the manufacturer were notified of the failure. The failure mileage was approximately 150,000.”

“I've had issues with my vehicle since 2021 -engine light first appeared on the dashboard and towed my car to a Jeep dealership. Vehicle was "repaired" (have the documentation, if needed), but the engine light remained on. I have since driven this vehicle for nearly 3 years with the engine light on, bringing it into different Jeep dealerships (all documentation on record if needed) to repair and was told there was nothing they could find wrong with the engine. Last year (2023) my electronic stability control and 4WD lights came on in addition to the engine light. My car was sliding all over the road and my 4WD was not engaging at all. Brought vehicle to Jeep dealership for repair, was told ABS module needs to be replaced and the traction control is malfunctioning; no 4 wheel drive engagement; that the ABS module has been discontinued and the only way to replace this is to get an after market part. Contacted Mopar and was told there is "no way of knowing if it's available and it's beyond their capability". I was told the after market part would be tied to a specific VIN. I then contacted the Jeep Dealership- Parts department and explained the situation, asking if…”

“Jeep turns off while driving and makes me put it into park to turn it back on and into drive again. Lights flicker from dim to bright inside and outside. I have changed both batteries and the alternator.”