2017 Jeep Renegade exterior lighting problems

“The contact owns a 2017 Jeep Renegade. The contact stated that while driving at an undisclosed speed, the message "Left Brake Light Failure" was displayed. The contact disassembled the rear driver's side brake light and discovered that the wiring harness, turn signal, and brake light were melted. The vehicle was taken to the dealer, but the vehicle was not yet repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 122,000.”

“Catalytic Converter. Part was recalled on the same engine but cuts off at 2016, however, my 2017 has the exact same engine and exact same issue as the recall issued to prior years. The problem has been confirmed by a dealership and mechanic. I have had a check engine light on to notify me of this error.”

“The car keeps shutting off while driving. Had to replace battery twice in the last few months. Also had relays replaced. Problem keeps happening. Something is draining the battery. I read there were problems with this make and model where even when the vehicle is shut off, certain connections remain active and drains. Shutting down with no warning while driving is very unsafe.”

“The rear driver side tail light, brake light, and turn signal stopped functioning at one time while driving (leaving a parking lot). Warning indicators for all 3 appeared on the dash notice area. Checked all lights and fuses for the 3 lights to ensure nothing was damaged or blown. All were fine. The issue is the center pin for the ground wire connecting the rear lighting housing had melted. This was determined after searching online for assistance to figure out the issue, as the lights and fuses were all in working order. Apparently this is extremely common in the 2017 Jeep Renegade specifically. It is a costly repair, which most people cannot repair themselves, myself included.”

“The grounding wire in the wiring harness of the driver's side, rear light assembly has melted. According to owner forums on the internet, there aren umerous reports of this being a problem.”

“Notification on dashboard that driver tail light, blinker, and brake lights were not on and need to be serviced. Took the vehicle to dealership. Bulbs were replaced and still not working. Was quoted that the connector and pigtail would need to be replaced with an estimate of $700. It is safety concern to try and switch lanes without a working indicator. There was a software update issued for the electrical system instrument panel ID 17V485000 that had not been completed. This software indicates a malfunction in the warning system lights. The tail light could have not been working before and the indicator light did not light up. All of the is occurred on November 17 2022”