2022 Jeep Wrangler power train problems

“The transmission on this 2022 Jeep Wrangler Sport 2-door (3.6L) has twice failed to shift / provide motive power, requiring a tow each time. First incident: XXX, about 20,812 miles. A transmission warning appeared and the vehicle would not shift out of Park. It was towed to Stevens Creek Chrysler Jeep Dodge Ram, [XXX], Repair Order XXX. The dealer found DTC U11C2, replaced a new OEM Mopar valve body and a new Transmission Control Module, programmed them and road-tested the vehicle. It was picked up XXX. Second incident: XXX, about 21,209 miles. The transmission again would not go into gear and the vehicle could not move. It was towed XXX to the same dealer, Repair Order XXX, opened XXX and still open. The dealer says Jeep wants another valve-body replacement before condemning the transmission. Safety concern: loss of motive power / inability to shift, twice, without warning, can leave the vehicle unable to move and creates crash and stranding risk. No crash, fire, injury or fatality is reported for these incidents. The owner considers this a serious safety concern impairing use, value and safety. Prior damage: only a comprehensive insurance claim for rodent…”

“Today is 10/19/2026. I have a 2022 Jeep Wrangler 4Xe Rubicon that has completed all of its safety recalls and recall notices. Each recall notice has been completed and each was marked as having no issues found. After completion of recall notice 68C (NHTSA 25V-741), we began to experience a complete change in how the car operates based on the vehicle mode selected on the 3 button panel (Hybrid, Electric, E-Save). We are now experiencing a consistent inappropriate kicking in of the gasoline engine when selecting and driving in the "Electric" only mode. Our normal driving of this car has occurred on the same roadways since we purchased the car from dealer stock. Prior to the Safety recall notice referred to as "68C/NHTSA 25V-741), we could select the "Electric" mode button on the 3 button panel selection and our 4Xe would run exclusively in the electric mode until it approached or reached the 1% mark. Now, the vehicle will kick in the gasoline engine even when the electric charge is above 50% ( I have actually had it kick in at the 75% mark). In addition, when this happens, the engine will rev to the 3000-4000rpm range unlike when the selection mode is chosen for…”

“i PURCHASED MY 2022 JEEP RUBICON 4XE USED ON MARCH 31, 2026. IN APRIL, I HAD A RECALL NOTICE FOR RECALL 68C. I TOOK IT TO MY JEEP DEALER AND HAD THE RECALL DONE. IMMEDATELY, I NOTICED THAT MY ACCELERATION IN ELECTRIC MODE & HYBRID MODE IS DRASTICALLY REDUCED TO THE POINT OF BEING UNSAFE. ATTEMPTING TO MERGE OR PULL OUT INTO TRAFFIC, THE VEHICLE NO LONGER ACCELERATES LIKE IT DID BEFORE THE RECALL 68C WAS DONE. IT FELLS LIKE I AM DRIVING WIHT MY EMERGENCY BREAK ENGAGED, AS THE VEHICLE WILL NOT ACCELERATE NORMALLY. THE DEALER ADVISED THAT EVERYTHING IS NORMAL, HOWEVER IT IS VERY DIFFERENT. I WOULD NOT HAVE BOUGHT THE VEHICLE IF IT HAD A HESITATION WHEN ACCELARATING. LOOKING ONLINE FOR SUGGESTIONS, I DISCOVERED THAT THOUSANDS OF JEEP WRANGLER 4XE OWNERS WHO HAD THE 68C RECALL DONE, HAVE EXPERIENCED THIS ISSUE. I AM SURPRISED THAT NO ONE HAS BEEN KILLED OR SERIOSLY INJURED DUE TO THE HESITATION, CAUSED BY THE RECAL. I WOULD RATHER DEAL WITH THE POSSIBLE RISK OF FIRE THAN HESITATION CAUSED BY THE RECALL "FIX", IN THIS CASE THE CURE IS FAR WORSE AND MORE DANERIOUS THAN THE DISEASE/ISSUE JEEP WAS TRYING TO FIX WITH 68C.”

“I own a 2022 Jeep Wrangler Sahara 4xe. My vehicle underwent Recall 68C and related high-voltage battery evaluation/software work. The high-voltage battery was later replaced by Jeep under warranty. Immediately after that battery replacement, I noticed a significant change in the vehicle’s propulsion behavior that I had not experienced before. Prior to the replacement, when Electric mode was selected and sufficient battery charge was available, the vehicle normally remained on electric propulsion. Since the warranty battery replacement, the gasoline engine can engage unexpectedly even though Electric mode is selected and usable battery charge remains. I have also experienced hesitation during acceleration, including a delay or change in propulsion response before the gasoline engine engages. This has occurred repeatedly since the battery replacement and was not characteristic of the vehicle beforehand. I am concerned that the battery replacement, Recall 68C-related software, or associated battery/propulsion-control calibration may have altered the vehicle’s electric-mode operation. I consider this a safety concern because predictable acceleration is important…”

“68C recall software update has caused some form of loss of power, doesn’t fully power off, it feels as if it is throttling the electric motor causing the engine to suddenly start and rev high (5-7k RPM) bypassing the warm up time that’s built into the software for the engine. Now on 09/14/2026 (Monday) the vehicle through a DTC code “P0BBE-00” High Voltage Battery Voltage Variation. It went into limp mode while attempting to drive up the roll back (flatbed tow truck). Currently awaiting Dealer diagnostic.”

“I am submitting this complaint regarding a critical electrical issue and potential safety hazard that occurred immediately after the 68C safety recall software update was performed. Since the 68C recall completion, my vehicle has experienced significant overnight High Voltage (HV) battery drain, losing approximately 10% of its state of charge while parked and powered off. I have returned the vehicle to the dealership three times for diagnostic testing. On the most recent visit, the dealership, working with Jeep engineers, claimed that the radio system fails to sleep, causing a continuous power draw from the battery. However, the dealership and Jeep engineer attributed this failure to a dash cam plugged into the factory 12V auxiliary power outlet (cigarette lighter socket). I believe this diagnosis is technically flawed and incorrect: The factory 12V outlet is off when the vehicle is powered down, meaning no current is drawn by the accessory once parked. The dash cam has been in continuous use since I purchased the vehicle without any issues; this battery drain issue began exclusively after the 68C software update. Blaming standard user accessories for the…”