2009 Nissan Murano service brakes problems

“My 2009 Nissan Murano had a bad battery and starter, after replaced them the ABS/VDC/Slip control light were illuminated and ABS function lost. I searched online and found a lot of the Murano owners had the same issue by just replacing a battery then got these DTCs. At the end we found Nissan know this issue and issue a TSB for repair with customer's expense. They know this is factory issue but not recall it or even not notify their customer, it's safety issue and still need the customer to search it and repair with the customer's money (to pay their faults). TSB: NTB10-113a”

“When driving at a slow speed and applying full brakes, the car rather than stopping quickly took more time to stop and thus resulted in an accident - collided with the car in front. There was a recall for this car in 2019 for exactly this problem - R1814. Apparently, the fix the dealer has performed didn’t alleviate the problem. I sincerely request you to perform a thorough assessment of the recommended fix for this recall to safeguard others from this serious safety issue. Also, if possible, I request you to arrange for assessment of my vehicle to confirm if my ABS concerns are true which I truly believe they’re.”

“While trying to make a turn in a busy intersection, the car stall and loses power it goes into a limp mode. The car slowly limps out of traffic to the side. Note VDC off and 2 red - neg sign brake light is on. Turn the ignition off for a few minutes. Turn ignition back on and no problem. The car starts up no problem. I had the brakes check out and no issues. I took to Nissan dealership . They said it is the alternator. I had new alternator put in 6 months ago. Took back to the company who put the alternator on He said it is working. They said this car notorious for the CVT transmission issues. This problem has happen twice in traffic. This is not safe.... I am afraid to drive this car.”

“Brake pedal now goes to floor before brakes engage. This occurred after stopping suddenly. Mechanic changed master cylinder and bled system but no change. No warning lamps on dashboard.”

“The brake pedal gets really stiff, hard to depress and the brakes gradually engage until they almost stop the vehicle. All the brakes get extremely hot when this occurs.”

“MY VEHICLE INSPECTION REPORT ON 01/04/2021 RECALL ADVISORY STATED "YOUR VEHICLE HAS ONE OR MORE RECALLS". I FOLLOWED ALL INSTRUCTIONS AND FOUND THAT THERE IS A PROBLEM WITH MY NC VALVE.”