2010 Nissan Murano service brakes problems

“brakes/ ABS brake system: Still in use currently. Not reproducible, very erratic; once every few days of operation. No outside inspections to date. No warning lights of messsages/ error codes before or after the brake failure. Event: Brake will fail on rare occasions randomly. No particular event precedes the failure: (corner; speed; trip duration; road vibration; etc). When brake is pressed, pedal drops to near the floor before giving some back pressure. No noticeable speed reduction here. If brakes are pumped they will begin to delevope pressure with some reduction in velocity. After several more pumps the brake activation returns and car can be stopped. No accident from this problem yet. Brake reservoir is full and has been full during these problems. This seems very similar to the 2009 murano recall for ABS system failure. NHTSA Campaign Number 18V916. Murano did a prior recall repair around 2020ish, and changed to DOT4 I think. That is the indicated fluid for this system. Very dangerous, and completely unexpected failure; luckily the emergency brake still works.”

“I am reporting an ABS/braking safety issue with my 2010 Nissan Murano. My vehicle was included in Nissan campaign P0A08/NTB21-047 involving brake fluid and the ABS actuator. Before the campaign, I had experienced an intermittent braking problem during a loss-of-traction/ABS event. When Nissan performed P0A08 on 8/8/2023 at 191,017 miles, I specifically reported the problem. The Nissan repair order states: “CUSTOMER STATES IS HAVING PROBLEMS WITH THE BRAKE PEDAL GOING TO FLOOR.” The ABS actuator passed Nissan’s campaign inspection, but because of my complaint, the service manager contacted Nissan/WCC regarding actuator replacement. The repair order states: “SERVICE MANAGER CALLED WCC TO VERIFY COVERAGE OF ABS ACTUATOR AFTER IT PASSED INSPECTION FOR RECALL.” Nissan case J0003385169 was opened. The intermittent condition could not be duplicated during a test drive, so the actuator was not replaced. On 8/20/2026, ABS, BRAKE, SLIP and VDC OFF warning lights began illuminating while driving. Nissan diagnosed ABS code C1140 – ACTUATOR RLY. After further testing, the Nissan repair order states: “CIRCUIT GOOD… INTERNAL CONCERN WITH ABS ACTUATOR.” Nissan now recommends…”

“The brake pedal suddenly feels spongey out of nowhere. The car stops when the pedal hits the floorboard of the car. This has happened to me a couple of times now ever since I had my car. I have took it to my local pep boys but all they did was replace my brake pads. It fixes the problem for a couple months but it ends up happen again. There are no warning lights showing up for my ABS or any of the braking system.”

“My car’s ABS failed to turn on even when braking from a far enough distance in the snow and caused me to rear end a car at 5 mph. I was holding down the brakes from 20 cars away and it felt like my brakes were unresponsive and all the way to the floor as my car continued sliding. Nissan’s voluntary recall was performed of flushing out the brake fluid and replacing it with the DOT 4 and it still failed as a working remedy for its defective ABS from what I have read from other owners. I love my car but might have to sell due to feeling unsafe driving in the snow. Please fix this Nissan before another accident occurs due to your defective ABS.”

“The contact owns a 2010 Nissan Murano. The contact stated that the brake pedal would intermittently depress to the floorboard without warning. The contact initially had a family member replace the brake master cylinder; however, the failure returned the following day. The contact then took the vehicle to an independent mechanic who recommended that the ABS actuator be replaced. The contact then called the manufacturer and was informed that there was a recall on her vehicle for a brake fluid flush, and the vehicle was towed to a dealer. A diagnostic test was performed, and a brake fluid flush was also performed on the vehicle. The failure returned soon after the repair. The contact took the vehicle back to the dealer and was informed that she had to pay a diagnostic fee to determine the cause of the failure. The vehicle had yet to be repaired and remained in the possession of the dealer. The failure mileage was approximately 110,300.”

“WHILE DRIVING UNDER NORMAL CONDITIONS, 35-50 MPH, DRY, GOOD, SMOOTH, STRAIGHT ROAD CONDITIONS, I APPLIED THE BRAKES AND THE PEDAL WENT ALMOST TO THE FLOOR BEFORE THE BRAKES STARTED BEING APPLIED. I HAVE SINCE LEARNED OF A RECALL FOR PRIOR MODEL YEARS (18V916000) AND SUBSEQUENT MODEL YEARS OF MY VEHICLE DUE TO ABS PROBLEMS. PART OF THE FIX IS TO REPLACE THE DOT3 FACTORY-SPECIFIED BRAKE FLUID SPECIFIED FOR MY VEHICLE WITH DOT4 BRAKE FLUID DUE TO CORROSION OF BRAKE SYSTEM COMPONENTS. I HAVE DETERMINED THAT IT IS IN FACT AN ABS PROBLEM, AS I CAN NOW SKID THE TIRES DURING HEAVY BRAKING, AND THE ANTI-LOCK BRAKE PUMP DOES NOT ACTIVATE. THE BRAKE PEDAL TRAVELS ABOUT 75 PERCENT OF THE DISTANCE TO THE FLOOR BEFORE ANY BRAKING OF THE VEHICLE OCCURS.”