Problems · by component
2003 Toyota 4Runner steering problems
35 owner complaints to NHTSA about the 2003 Toyota 4Runner cite steering, 5% of all 708 complaints for this model year.
Complaints
35
5% of all complaints
Crashes
1
Reported by owners
Fires
0
Reported by owners
Injuries
1
Reported by owners
What owners say about the steering
Verbatim from NHTSA complaints, newest first
“There is severe rust on the frame, the rear is listing by 3/4 of an inch due to suspension rust, parts of the frame are perforated and lots of rust can fall out of drain holes when tapped. I am unable to steer the truck due to the intermediate steering column rust. The Tacoma was recalled for the same reason, I am assuming the 4runner has not been recalled because it was manufactured in greater numbers, and therefore more costly to repair, the danger of the severe rust is the same in both vehicles.”
“Stabilizer bar connected to the frame rusted off,back passenger side! Causing the vehicle to sway uncontrollably, due to the low rate of speed, I was able to regain control of my vehicle and not drive off the bridge I was driving over at the time or crash into another vehicle. The engine runs great, everything works, the vehicle still looks good but the frame is rusting out from underneath it! Toyota Needs To Make It Right!”
“Stabilizer bar connecting the axle to the frame rusted off. I was driving only 25-30mph at the time, luckily. The vehicle swayed violently almost causing an accident and nearly forcing me off the bridge I happened to driving over. Very fortunate no one was hurt and nothing was damaged from the incident. You can imagine the tragedy if that had happened on the highway driving 75mph! Major accident, innocent lives damaged or lost. This is a very dangerous vehicle not only to the driver and passengers but also to anybody that happened to be innocently in the path of an out of control Toyota 4runner. Toyota Please fix this, for your safety and everyone else on the highway. People should be warned!!”
“Vehicle frame and suspension components are completely rusting out. Having issues with the corroded steering column lower shaft not allowing the vehicle to turn properly.”
“At the end of June 2021, while driving I experienced a loud clunk and grinding noise, with reduced control of steering and brakes on my 4Runner. I took the 4Runner to a Goodyear Automotive Service Center on Woodward Avenue in Royal Oak, Michigan, who told me that the vehicle was not driveable due to severe rust damage of the frame that resulted in a broken sway bar. I thought I should take it to the closest Toyota dealership in Troy, Michigan for advice and they responded that the vehicle was beyond repair and that a new frame would cost around $20,000. I could not leave my car there, and risked driving it home, where it has been parked ever since.”
“Frame is rotted out and brake lines attached to the frame as well as every suspension component. Car failed inspection deemed unsafe to drive. This problem has been addressed for Tacoma, tundra and sequoia but not 4runner. These frames have the same issue as those and needs to be repaired by Toyota due to lack of rust and corrosion protection. There’s no reason 4runner should be overlooked for the same issue as the other full frame trucks.”
Showing 6 of 35 reports. Read every report on NHTSA.gov.
Data from NHTSA Complaints API (owner reports, unverified) · synced Nov 11, 2026NHTSA vehicle page
Complaints are unverified owner reports to NHTSA and are not normalized for sales volume. One complaint can cite several components.