2013 Toyota Prius service brakes problems

“On XXX, at approximately 152,570 miles, the brake, ABS, and traction-control warning lights illuminated at the same time on my 2013 Toyota Prius. The brakes felt spongy, and I heard a recurring buzzing sound approximately every 3 seconds. Because of the change in brake-pedal feel and concerns about braking safety, I stopped using the vehicle. I reported the problem to Longo Toyota in [XXX], which directed me to Toyota customer support. The vehicle was subsequently diagnosed with trouble code C1391, “Internal Leak in Accumulator.” I contacted the dealership and Toyota customer support about Customer Support Program ZJB, which addressed code C1391 brake booster and brake booster pump failures. Toyota denied coverage because the failure occurred outside the program’s time and mileage limits. The symptoms began only 2,570 miles beyond the 150,000-mile limit. My primary concern is **safety**, not simply the expiration of coverage. The vehicle developed spongy brakes, multiple warning lights, and frequent buzzing. The diagnosis appears consistent with the type of brake-system failure Toyota previously addressed through ZJB. I request that NHTSA investigate whether…”

“While driving our 2013 Toyota Prius, the vehicle experienced a sudden and severe loss of braking effectiveness while the vehicle was in motion. This created an immediate safety risk because the vehicle did not respond to braking as expected. After the incident, the vehicle displayed the red BRAKE warning light, ABS warning light, brake-system warning light, and an audible warning. The vehicle was not driven after the failure and was transported to a Toyota dealership for diagnosis. The dealer confirmed a brake-system fault and recorded diagnostic trouble codes C1241, C1252, C1253, and C1256. Toyota previously issued Customer Support Program ZJB for certain 2010–2015 Prius vehicles involving internal brake booster and brake booster pump malfunctions. Toyota’s documentation for that condition identifies C1252, C1253, C1256, and C1391 as relevant diagnostic codes. This vehicle has three of those listed codes. The problem has been confirmed by the Toyota dealership. The failed brake-system components remain installed and are available for inspection at this time. There were no known brake-system warning lamps before the braking failure. The warning lamps and…”

“While driving, my brake pedal would randomly lose power assist. The pedal would get hard and I couldn't press it down normally, and I had to push as hard as I could just to get the car to slow down. This happened more than once while driving and I almost crashed because I couldn't stop the car in time. A scan later showed codes C1252 (brake booster pump motor on-time abnormally long), C1253 (pump motor relay fault), and C1256 (accumulator pressure low), pointing to a failure in the brake booster pump/accumulator system. A repair shop confirmed this and said the brake booster assembly with master cylinder and the brake booster pump assembly with accumulator both needed to be replaced. I also contacted Toyota and was told my car was previously covered under a Warranty Enhancement Program for this exact part, which has since expired meaning this is a known issue with this component. The part is available for inspection if needed.”

“The break pump for my 2013 prius is going out and is a known issue with Toyota. I contacted toyota and they have stated because it is past the extended warranty they can not repair it and aren't liable for it. I bought the car used and was unaware that it has been a known issue for years. The previous owner did not have it replaced as they were probably unaware as well. It is a highly unsafe issue and has caused my breaks to suddenly go our while driving recently with my toddler. It is also $3000-$5000 to fix it and is almost more than the cars value. I need help resolving this as it isn't "normal wear and tear" or a mileage issue. It is a known, very public defect that toyota has admitted and I have been able to easily find information on all over Google. The warning lights came on out of no where on the freeway today.”

“I purchased a 2013 Toyota Prius from a reputable dealership in Omaha (O'Daniel Honda). 5 days after purchase the ABS, BRAKE, and Traction Control lights came on in the evening. When I took it to the dealership the next day they had cycled off and the dealership couldn't find anything wrong. A few days later it happened again so I got into the dealer right away and they said Toyota had issued a service bulletin C1391 in 2019, and that I would have to replace the brake booster, brake cylinder, and brake pump assembly. I'm still fighting with the dealership to make this right, because they should have caught this during their inspection before putting the car for sale on their lot. The indicator lights keep cycling on and off. Something that effects the braking system should be a recall and not a service bulletin.”

“My vehicle has 105492 miles and ABS light, Trackion and Brake light went on. I could hear a buzzing sound from the brake actuator every 5 seconds. The brake actuator and master cylinder was failing. According to the dealership failure of brake actuator and master cylinder is a common safety issue with Toyota Prius. The failure of the actuator can lead to failure in the braking system and a crash. Online research shows that several customers have reported this issue. The Claremont Toyota quoted me $3646 to fix this issue. I contacted Toyota of America and they informed that they cannot cover these repairs case number 260515002576.I took my vehicle to a private mechanic. I paid $2312 for parts and labor to fix this safety issue. I would like to file a complaint against Toyota for not addressing this critical safety issue.”