C0571Chassis · ABS & brakesGeneric (SAE) code

C0571: Active Brake Assist Performance

The brake assist or driver assistance module has detected that brake assist performance is degraded. The system may fail to autonomously build pressure during emergency braking and emergency brake assist functions are limited.

Typical labor cost
$125–$625 est.
1 h–5 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Active booster slow or weak
DIY difficulty: Hard · usually a shop job
01 —What it means

What C0571 means

C0571 is a generic OBD-II chassis code in the ABS & brakes group. In plain English: the signal is within electrical limits but doesn’t make sense compared with other readings, so the part or system isn’t performing as expected.

C
Chassis
0
Generic (SAE)
5
Subsystem group
71
Specific fault
How to read C0571. We group it under ABS & brakes.
Check engine light
Usually off
Emissions-related
No
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Symptoms

Symptoms

What drivers typically notice
  • ABS warning light on
  • ESC/stability control deactivated
  • Possible reduced brake assist
  • Speedometer may behave erratically
Code data: OBDex (CC0)
03 —Causes

Common causes

Ranked from most to least likely
  1. 01Active booster slow or weakMost likely
  2. 02Secondary fault on related sensorPossible
  3. 03System calibration required after repairLess likely
Code data: OBDex (CC0)
04 —Severity

Can I drive with C0571?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Usually lights the ABS, traction or stability warning instead of the check engine light

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
05 —Diagnosis

How to diagnose C0571

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just C0571. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Fix other faults first

    If other codes are stored, start with power-supply, sensor-circuit and communication codes. They can cause this code as a side effect.

  3. 3

    Check live data

    Watch the related sensor and actuator readings in live data (Active brake booster, Brake assist module, Brake pressure sensor) and compare them with expected values in the service information for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Active booster slow or weak; secondary fault on related sensor; system calibration required after repair. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
06 —Cost

C0571 repair cost estimate

Labor only — set your local shop rate
Labor estimate for C0571
$125–$625
1 h–5 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Hard
Good DIY job?
Usually a shop job

Involved testing or major parts. Most owners use a shop.

Code data: OBDex (CC0)
07 —Components

Parts and systems involved

  • Active brake booster
  • Brake assist module
  • Brake pressure sensor
Code data: OBDex (CC0)
09 —FAQ

C0571 FAQ

What does C0571 mean?

C0571 means “Active Brake Assist Performance”. The brake assist or driver assistance module has detected that brake assist performance is degraded. The system may fail to autonomously build pressure during emergency braking and emergency brake assist functions are limited.

Is C0571 serious? Can I keep driving?

We rate C0571 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes C0571?

The most common causes, from most to least likely: Active booster slow or weak; Secondary fault on related sensor; System calibration required after repair. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix C0571?

Typical labor is about $125–$625 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix C0571 myself?

DIY difficulty is hard. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will C0571 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)