C0700Chassis · SteeringGeneric (SAE) code

C0700: Active Steering Module Communication

A communication fault between the chassis control module and the active steering module has been detected. Active steering varies the steering ratio with speed, and a fault disables this assistance and may store secondary codes in other modules.

Typical labor cost
$65–$500 est.
30 min–4 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Communication bus fault
DIY difficulty: Hard · usually a shop job
01 —What it means

What C0700 means

C0700 is a generic OBD-II chassis code in the steering group.

C
Chassis
0
Generic (SAE)
7
Subsystem group
00
Specific fault
How to read C0700. We group it under Steering.
Check engine light
Usually off
Emissions-related
No
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Symptoms

Symptoms

What drivers typically notice
  • ABS warning light on
  • ESC/stability control deactivated
  • Possible reduced brake assist
  • Speedometer may behave erratically
Code data: OBDex (CC0)
03 —Causes

Common causes

Ranked from most to least likely
  1. 01Communication bus faultMost likely
  2. 02Active steering module failedPossible
  3. 03Power supply or ground fault to moduleLess likely
Code data: OBDex (CC0)
04 —Severity

Can I drive with C0700?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Usually lights the ABS, traction or stability warning instead of the check engine light

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
05 —Diagnosis

How to diagnose C0700

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just C0700. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Fix other faults first

    If other codes are stored, start with power-supply, sensor-circuit and communication codes. They can cause this code as a side effect.

  3. 3

    Check live data

    Watch the related sensor and actuator readings in live data (Active steering module, Communication bus, Chassis control module) and compare them with expected values in the service information for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Communication bus fault; active steering module failed; power supply or ground fault to module. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
06 —Cost

C0700 repair cost estimate

Labor only — set your local shop rate
Labor estimate for C0700
$65–$500
30 min–4 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Hard
Good DIY job?
Usually a shop job

Involved testing or major parts. Most owners use a shop.

Code data: OBDex (CC0)
07 —Components

Parts and systems involved

  • Active steering module
  • Communication bus
  • Chassis control module
Code data: OBDex (CC0)
09 —FAQ

C0700 FAQ

What does C0700 mean?

C0700 means “Active Steering Module Communication”. A communication fault between the chassis control module and the active steering module has been detected. Active steering varies the steering ratio with speed, and a fault disables this assistance and may store secondary codes in other modules.

Is C0700 serious? Can I keep driving?

We rate C0700 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes C0700?

The most common causes, from most to least likely: Communication bus fault; Active steering module failed; Power supply or ground fault to module. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix C0700?

Typical labor is about $65–$500 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix C0700 myself?

DIY difficulty is hard. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will C0700 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)