P0415Powertrain · EmissionsGeneric (SAE) code

P0415: Secondary Air Injection System Switching Valve B Circuit

Secondary Air Injection System Switching Valve B Circuit: an electrical fault is present in the circuit.

Typical labor cost
$65–$315 est.
30 min–2.5 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Solenoid fault
DIY difficulty: Moderate · DIY-friendly
01 —What it means

What P0415 means

P0415 is a generic OBD-II powertrain code in the emissions group. In plain English: the computer found an electrical fault in that circuit: an open, short or bad connection, or a failed component.

P
Powertrain
0
Generic (SAE)
4
Subsystem group
15
Specific fault
How to read P0415. We group it under Emissions.
Check engine light
Usually on
Emissions-related
Yes — can fail inspection
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Causes

Common causes

Ranked from most to least likely
  1. 01Solenoid faultMost likely
Code data: OBDex (CC0)
03 —Severity

Can I drive with P0415?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Turns on the check engine light
  • Emissions-related: will usually fail an OBD inspection

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
04 —Diagnosis

How to diagnose P0415

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just P0415. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Check for related codes first

    Look for P0412. Related codes often share a cause; a circuit or sensor code usually needs fixing before a performance code like this one.

  3. 3

    Test the circuit

    Inspect the wiring and connector at the secondary air injection valve for damage, corrosion or chafing. With a multimeter, check supply voltage, ground and signal against the specifications in the service manual for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Solenoid fault. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
05 —Cost

P0415 repair cost estimate

Labor only — set your local shop rate
Labor estimate for P0415
$65–$315
30 min–2.5 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Moderate
Good DIY job?
Yes, with a scan tool

Needs a scan tool and some experience with testing.

Code data: OBDex (CC0)
06 —Components

Parts and systems involved

  • Secondary air injection valve
Code data: OBDex (CC0)
08 —FAQ

P0415 FAQ

What does P0415 mean?

P0415 means “Secondary Air Injection System Switching Valve B Circuit”. Secondary Air Injection System Switching Valve B Circuit: an electrical fault is present in the circuit.

Is P0415 serious? Can I keep driving?

We rate P0415 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes P0415?

The most common causes, from most to least likely: Solenoid fault. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix P0415?

Typical labor is about $65–$315 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix P0415 myself?

DIY difficulty is moderate. Many owners can handle it with a scan tool, a multimeter and basic hand tools. Always confirm the cause before buying parts.

Will P0415 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)