P0475Powertrain · EmissionsGeneric (SAE) code

P0475: Exhaust Pressure Control Valve A

A general fault on exhaust pressure control valve A — used as a backpressure brake on heavy-duty diesels and to assist DPF regeneration by raising exhaust temperature.

Typical labor cost
$90–$440 est.
42 min–3.5 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Valve seized or solenoid failed
DIY difficulty: Moderate · usually a shop job
01 —What it means

What P0475 means

P0475 is a generic OBD-II powertrain code in the emissions group.

P
Powertrain
0
Generic (SAE)
4
Subsystem group
75
Specific fault
How to read P0475. We group it under Emissions.
Check engine light
Usually on
Emissions-related
Yes — can fail inspection
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Causes

Common causes

Ranked from most to least likely
  1. 01Valve seized or solenoid failedMost likely
Code data: OBDex (CC0)
03 —Severity

Can I drive with P0475?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Turns on the check engine light
  • Emissions-related: will usually fail an OBD inspection

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
04 —Diagnosis

How to diagnose P0475

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just P0475. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Check for related codes first

    Look for P049F. Related codes often share a cause; a circuit or sensor code usually needs fixing before a performance code like this one.

  3. 3

    Check live data

    Watch the related sensor and actuator readings in live data (Exhaust pressure regulator) and compare them with expected values in the service information for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Valve seized or solenoid failed. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
05 —Cost

P0475 repair cost estimate

Labor only — set your local shop rate
Labor estimate for P0475
$90–$440
42 min–3.5 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Moderate
Good DIY job?
Usually a shop job

Needs a scan tool and some experience with testing.

Code data: OBDex (CC0)
06 —Components

Parts and systems involved

  • Exhaust pressure regulator
Code data: OBDex (CC0)
08 —FAQ

P0475 FAQ

What does P0475 mean?

P0475 means “Exhaust Pressure Control Valve A”. A general fault on exhaust pressure control valve A — used as a backpressure brake on heavy-duty diesels and to assist DPF regeneration by raising exhaust temperature.

Is P0475 serious? Can I keep driving?

We rate P0475 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes P0475?

The most common causes, from most to least likely: Valve seized or solenoid failed. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix P0475?

Typical labor is about $90–$440 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix P0475 myself?

DIY difficulty is moderate. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will P0475 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)