P04EE: EVAP System Very Small Leak Detected Fuel Tank Side
Same as P04EA but at the most sensitive leak threshold - typically the OBD-II 0.020-inch (~0.5 mm) test. The system holds pressure for some time but loses it slower than the diagnostic limit allows; usually fuel cap O-ring fatigue or microcracks in a hose.
What P04EE means
P04EE is a generic OBD-II powertrain code in the emissions group. In plain English: the fuel-vapor (EVAP) system failed its leak self-test, so fuel vapor may be escaping from the tank, cap, hoses or valves.
- Check engine light
- Usually on
- Emissions-related
- Yes — can fail inspection
- Limp mode possible
- Not typical
- Drive cycle to clear
- Not required
Get it fixed
Post this code once and get quotes from local mechanics. Free to post.
Makes the repair and parts links below specific to your car. Kept in this browser only.
Symptoms
- Check engine light on
- Possible smell of fuel near tank or engine bay
- Failed emissions inspection
- Loose-cap warning may appear
Common causes
- 01Fuel cap O-ring aged or stiffenedMost likely
Can I drive with P04EE?
Generally yes.
This fault is unlikely to affect how the car drives, but it will usually fail an emissions inspection. Fix it when convenient.
Why we rate it low
- Turns on the check engine light
- Emissions-related: will usually fail an OBD inspection
- EVAP leaks rarely affect how the car drives
Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.
How to diagnose P04EE
- 1
Confirm the code and save freeze-frame data
Read the codes with an OBD-II scan tool and note every code, not just P04EE. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.
- 2
Fix other faults first
If other codes are stored, start with power-supply, sensor-circuit and communication codes. They can cause this code as a side effect.
- 3
Check the gas cap, then smoke-test
Inspect the fuel cap seal and make sure it clicks tight. If the code returns, a smoke test of the EVAP system finds cracked hoses, purge or vent valve leaks.
- 4
Test the likely causes in order
Start with the most likely cause and work down: Fuel cap O-ring aged or stiffened. Test before replacing parts.
- 5
Check for recalls and service bulletins
Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.
- 6
Clear the code and verify the repair
After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.
P04EE repair cost estimate
Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.
- DIY difficulty
- Easy
- Good DIY job?
- Yes, with a scan tool
Basic hand tools; a common first DIY job.
Parts and systems involved
- Fuel cap
- Fuel sender seal
- EVAP hose tank side
P04EE FAQ
What does P04EE mean?
P04EE means “EVAP System Very Small Leak Detected Fuel Tank Side”. Same as P04EA but at the most sensitive leak threshold - typically the OBD-II 0.020-inch (~0.5 mm) test. The system holds pressure for some time but loses it slower than the diagnostic limit allows; usually fuel cap O-ring fatigue or microcracks in a hose.
Is P04EE serious? Can I keep driving?
We rate P04EE as low severity. Generally yes. This fault is unlikely to affect how the car drives, but it will usually fail an emissions inspection. Fix it when convenient.
What causes P04EE?
The most common causes, from most to least likely: Fuel cap O-ring aged or stiffened. Test before replacing parts, because several causes can set the same code.
How much does it cost to fix P04EE?
Typical labor is about $25–$125 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.
Can I fix P04EE myself?
DIY difficulty is easy. Many owners can handle it with a scan tool, a multimeter and basic hand tools. Always confirm the cause before buying parts.
Will P04EE clear itself?
If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.