P0545Powertrain · EmissionsGeneric (SAE) code

P0545: Exhaust Gas Temperature Sensor Bank 1 Sensor 1 Low

The exhaust gas temperature sensor signal at bank 1, sensor 1 is below the lower diagnostic threshold. Indicates short to ground or sensor fault.

Typical labor cost
$65–$250 est.
30 min–2 h at an assumed $125/hr · parts extra · use your rate
Most common fix
EGT sensor internally faulty
DIY difficulty: Moderate · usually a shop job
01 —What it means

What P0545 means

P0545 is a generic OBD-II powertrain code in the emissions group. Bank 1 is the side of the engine with cylinder 1 (inline engines only have bank 1).

P
Powertrain
0
Generic (SAE)
5
Subsystem group
45
Specific fault
How to read P0545. We group it under Emissions.
Check engine light
Usually on
Emissions-related
Yes — can fail inspection
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Causes

Common causes

Ranked from most to least likely
  1. 01EGT sensor internally faultyMost likely
  2. 02Signal wire shorted to groundPossible
Code data: OBDex (CC0)
03 —Severity

Can I drive with P0545?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Turns on the check engine light
  • Emissions-related: will usually fail an OBD inspection

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
04 —Diagnosis

How to diagnose P0545

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just P0545. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Check for related codes first

    Look for P0546. Related codes often share a cause; a circuit or sensor code usually needs fixing before a performance code like this one.

  3. 3

    Test the circuit

    Inspect the wiring and connector at the exhaust gas temp sensor and sensor wiring for damage, corrosion or chafing. With a multimeter, check supply voltage, ground and signal against the specifications in the service manual for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: EGT sensor internally faulty; signal wire shorted to ground. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
05 —Cost

P0545 repair cost estimate

Labor only — set your local shop rate
Labor estimate for P0545
$65–$250
30 min–2 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Moderate
Good DIY job?
Usually a shop job

Needs a scan tool and some experience with testing.

Code data: OBDex (CC0)
06 —Components

Parts and systems involved

  • Exhaust gas temp sensor
  • Sensor wiring
Code data: OBDex (CC0)
08 —FAQ

P0545 FAQ

What does P0545 mean?

P0545 means “Exhaust Gas Temperature Sensor Bank 1 Sensor 1 Low”. The exhaust gas temperature sensor signal at bank 1, sensor 1 is below the lower diagnostic threshold. Indicates short to ground or sensor fault.

Is P0545 serious? Can I keep driving?

We rate P0545 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. Left alone it can raise fuel use and emissions and will fail an OBD inspection. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes P0545?

The most common causes, from most to least likely: EGT sensor internally faulty; Signal wire shorted to ground. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix P0545?

Typical labor is about $65–$250 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix P0545 myself?

DIY difficulty is moderate. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will P0545 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)