U0429Network · Invalid data & softwareGeneric (SAE) code

U0429: Invalid Data Received from Steering Wheel Angle Sensor

The Steering Wheel Angle Sensor is present on the data bus but the values it reports are implausible — out of range, frozen, or failing the checksum or rolling-count check. The receiving modules reject the data. Stability control loses a trustworthy steering-angle value. Causes include a faulty sensor feeding the module, internal computation errors, a software or calibration mismatch after a repair, or bus interference corrupting the frames.

Typical labor cost
$65–$375 est.
30 min–3 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Steering angle sensor not calibrated
DIY difficulty: Hard · usually a shop job
01 —What it means

What U0429 means

U0429 is a generic OBD-II network code in the invalid data & software group. In plain English: a module received data that didn’t make sense from the Steering Wheel Angle Sensor.

U
Network
0
Generic (SAE)
4
Subsystem group
29
Specific fault
How to read U0429. We group it under Invalid data & software.
Check engine light
Usually on
Emissions-related
No
Limp mode possible
Not typical
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Symptoms

Symptoms

What drivers typically notice
  • Multiple warning lights may illuminate
  • Affected modules may go into limp mode or shut down
  • Specific functions inoperative depending on module
  • Diagnostic tools may show communication faults
Code data: OBDex (CC0)
03 —Causes

Common causes

Ranked from most to least likely
  1. 01Steering angle sensor not calibratedMost likely
  2. 02Steering angle sensor failedPossible
  3. 03Gateway module routing CAN messages incorrectlyLess likely
Code data: OBDex (CC0)
04 —Severity

Can I drive with U0429?

Moderate

Usually yes, for a short time.

The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

Why we rate it moderate

  • Turns on the check engine light

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
05 —Diagnosis

How to diagnose U0429

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just U0429. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Fix other faults first

    If other codes are stored, start with power-supply, sensor-circuit and communication codes. They can cause this code as a side effect.

  3. 3

    Check module power, ground and the data bus

    Confirm the module named in the code has battery voltage, ignition feed and a good ground. With the battery disconnected, a healthy CAN bus usually measures about 60 ohms between CAN-High and CAN-Low at the OBD port. Inspect connectors for corrosion and pushed-out pins.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Steering angle sensor not calibrated; steering angle sensor failed; gateway module routing CAN messages incorrectly. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
06 —Cost

U0429 repair cost estimate

Labor only — set your local shop rate
Labor estimate for U0429
$65–$375
30 min–3 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Hard
Good DIY job?
Usually a shop job

Involved testing or major parts. Most owners use a shop.

Code data: OBDex (CC0)
07 —Components

Parts and systems involved

  • Steering angle sensor
  • CAN bus wiring
Code data: OBDex (CC0)
09 —FAQ

U0429 FAQ

What does U0429 mean?

U0429 means “Invalid Data Received from Steering Wheel Angle Sensor”. The Steering Wheel Angle Sensor is present on the data bus but the values it reports are implausible — out of range, frozen, or failing the checksum or rolling-count check. The receiving modules reject the data. Stability control loses a trustworthy steering-angle value. Causes include a faulty sensor feeding the module, internal computation errors, a software or calibration mismatch after a repair, or bus interference corrupting the frames.

Is U0429 serious? Can I keep driving?

We rate U0429 as moderate severity. Usually yes, for a short time. The car will often drive normally, but get it diagnosed soon. If you notice rough running, warning lights flashing, overheating or a burning smell, stop driving.

What causes U0429?

The most common causes, from most to least likely: Steering angle sensor not calibrated; Steering angle sensor failed; Gateway module routing CAN messages incorrectly. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix U0429?

Typical labor is about $65–$375 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix U0429 myself?

DIY difficulty is hard. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will U0429 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)