2019 Acura TLX problems

“- The engine ceased while the car was moving, causing (a) A sudden stop (b) Engine stopping and the car becoming inoperable in the middle of a street. - There were no injuries because the failure happened at low speed. The same failure on an expressway would be a major safety concern since the car came to sudden stop. - The failed engine was inspected by an authorized Acura dealer. Cause identified as cylinder 2 rod bearing failure. - There was a slight knocking sound right before the incident occured - The car was driving fine before the incident. There were no warning indicators. - The engine (short block) was replaced previously on the same car due to a knocking sound.”

“I am formally requesting a neutral third-party arbitration review under the Magnuson-Moss Warranty Act to compel American Honda Motor Co. to provide a permanent mechanical remedy—specifically, the sourcing and installation of a brand-new, redesigned engine assembly (Engine #Four)— This vehicle frame is now on its third engine block. Car was bought 11/30/2024. At Grubbs Acura, fuel pump safety recall that involves flashing/re-calibrating the Engine Control Unit (FI-ECU) software was done. Just a few weeks after new fuel pump, the vehicle displayed sudden stalling symptoms. The engine suffered a terminal, catastrophic internal collapse. The vehicle was towed to Grubbs Acura where Corporate Honda directed a forced out-of-pocket internal engine teardown. The physical teardown explicitly confirmed a catastrophic connecting rod bearing failure (spun bearing) identical to the structural manufacturing flaws currently under active federal investigation by the NHTSA under Preliminary Evaluation PE25008 / RQ24-025. Corporate Honda subsequently issued a verbal agreement to fully reimburse my out-of-pocket teardown fees. Because a manufacturer will never fund diagnostic…”

“The contact owns a 2019 Acura TLX. The contact received notification of NHTSA Campaign Number: 23V751000 (Engine and Engine Cooling). The contact stated that while driving approximately 55 MPH, the vehicle lost power and the steering wheel failed to responded as needed. The vehicle stalled in the middle of the road. The vehicle was restarted but stalled immediately. The contact inspected the vehicle but found no fault. The vehicle was towed to an independent mechanic where it was diagnosed that the rod bearing had failed and the engine needed to be replaced. The vehicle was not repaired. The vehicle was then towed to a dealer where it was diagnosed that the rod bearing had failed and that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 120,000.”

“The contact owns a 2019 Acura TLX. The contact received notifications of NHTSA Campaign Numbers: 23V858000 (Fuel System, Gasoline) and 23V751000 (Engine and Engine Cooling); however, the parts to do the recall repairs were not yet available. The contact stated that the dealer had exceeded a reasonable amount of time for the recall repairs. The dealer was made aware of the issue and confirmed that parts were not yet available. The contact was placed on a waitlist for the recall repairs. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.”

“All of Sudden i got Electronic Parking Brake/Emissions System Problem today 08/26/2025 and hence reporting this and quick internet research shows so many people having same issue”

“I am filing a formal safety complaint regarding the execution of NHTSA Recall 24-002 (Connecting Rod Bearing Replacement) by an authorized Acura dealership, and a fundamental safety flaw in Acura’s official Service Bulletin for this recall. My vehicle underwent "Repair #1" under this recall, which involved opening the engine block and replacing the rod bearings due to a factory defect that causes metal-on-metal wear. However, upon picking up my vehicle, I discovered the dealership left the old, dirty oil filter attached to the engine. I reviewed Acura’s Service Bulletin 24-002 and realized the "Required Materials" list explicitly omits a new oil filter for Repair #1. Because dealerships strictly follow this bulletin for warranty reimbursement, they are systematically leaving old filters on engines that just received new bearings. This means old, metal-contaminated oil trapped in the filter is immediately recirculated through the brand-new precision bearings. This procedural flaw directly jeopardizes the integrity of the engine, completely undermining the purpose of the safety recall and putting drivers at risk of sudden engine failure at highway speeds. I have…”