2004 Cadillac SRX electrical system problems

“Ran out of gas after putting gas in the car tried to start it and the ignition got stuck and continued to try to start on its own I had to pull the back to the off position I tried to start it again and it would not start and the lights on the dash And the radio control center did not come on. And car will not even try to start before this the car had been cutting off while driving down the road for no reason and it kept showing a check stability control warning and low tire pressure even though tires were not low at all”

“I WAS DRIVING AND THE VEHICLE JUST CUT OFF ON ME EVERY THING LOCKED UP EVEN THE BRAKES I COULDN'T STOP SO I CHUNKED THE GEAR IN PARK TO AVOID FROM SMASHING INTO ANYONE I WAS SO AFRAID BUT IT CRANK RIGHT UP AFTER BUT I NOTICED THE TEMPERATURE GAUGE AND THE GAS GAUGE WAS NO LONGER WORKING..”

“MY CAR WAS SITTING IN THE DRIVEWAY WHEN I STARTED TO DRIVE OFF THE CAR JERKED A LITTLE THEN I APPLIED THE BREAK. STILL IN THE DRIVEWAY,I TRIED TO CONTINUE ON BUT NOTICED THE CAR WOULDN'T MOVE. AHAD IT PLACED ON A CODE READER,P2122,ACCELERATOR POSITION SENSOR CIRCUIT D LOW .REPLACED PEDAL,STILL THE SAME THING. *TR”

“SO MANY RUSTED FRAME COMPLAINTS SHOULD HAVE WARRANTED A RECALL. IN MY CASE A FRAME SHOULD NOT HAVE RUSTED BADLY IN LESS THAN A YEAR . MANY EVEN SHOW ON YOU -TUBE TRYING TO FIX RUSTED FRAMES BECAUSE NO ONE IS LISTENING. UNDERBODY COATING ACTUALLY SHOULD HAVE BEEN ADDED . THIN SHEET METAL SECTIONS ARE THE WORST PARTS .”

“STABILITY TRACTION CONTROL AND ANTI-LOCK BRAKES AND CHECK ENGINE LIGHT WILL NOT GO OFF EVEN AFTER COMPUTER MODULE WHEEL BEARINGS 02 SENSORS WERE CHANGED WHILE DRIVING ON LOCAL CITY STREETS IN MOUNT VERNON NY WHILE TURNING THE ANTI LOCK BRAKES ENGAGES AND MAKES THE BRAKE PEDAL SHAKE AND THE STEERING WHEEL GETS TIGHT THIS HAS BEEN HAPPENING FOR ABOUT 2 YEARS NOW AND ONGOING”

“TL* THE CONTACT OWNS A 2004 CADILLAC SRX. THE CONTACT STATED THAT THE TRACTION CONTROL SYSTEM AND CHECK ENGINE WARNING INDICATORS WERE ILLUMINATED ALL THE TIME. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO DETERMINED THAT THERE WAS WATER INTRUSION THAT SHORTED THE HARNESS ON THE INSTRUMENT PANEL. THE VEHICLE WAS NOT TAKEN TO THE DEALER FOR DIAGNOSTIC TESTING. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND PROVIDED CASE NUMBER: 95047378414. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 30,000.”