2011 Chevrolet Cruze service brakes problems

“I bought my car used. I have replaced the Brake Pedal Position Sensor 3 times on my own and 1 time by Anderson General Tire. Sometimes when I go to brake, there is no brake and I have to push real hard with my foot and finally the car will brake. It feels as if my brakes go out and sometimes I have to pump the brake pedal. It happens also when I start my car after it's been sitting and I brake to shift into drive. My car says it doesn't have any recalls but I have been having this problem. My car has been serviced numerous times by Chevrolet immediately after buying it. I only had to stop taking it there because my warranty ran out and then they wouldn't cover the costs anymore. Codes that come up are P057D and U0140-71: Brake Pedal Position Sensor Circuit High and Brake Pedal Position Sensor Circuit High Voltage and Anti-lock Brake System (although this does not show on the dash).”

“Last month the car started ti show me this errors Stabili Trak Control and Traction Service Control, I keep getting them driving on the highway, every road I drive, the steering wheal just becomes stiff and its hard to maneuver , the Air Condition turns off itself and the car has a big vibration , like there is an earthquake outside, I have been calling General Motors to tell them about the problem but they are telling me there is nothing they can do. There are times when I get in the car trying to get to work and the car won't start, the car would show me the errors and would not clear for hours, it's a nightmare.”

“I drive daily taking 2 freeways. I stopped at the traffic light and the car felt like shaking. Stabilitrack warning and traction control warning light and messages appeared on the screen and also the check engine light turned on, and ABS too. Break pedal was really hard to push and breaks were not working (i was not reducing speed at all) and it felt like the engine loose power and the car felt rough while driving. I was approaching to another traffic light and it was a red light so I prepared to decrease my speed and stop to wait for the green light. When I placed my foot and pressed the break pedal, it was hard. I was pushing it hard but the pedal did not respond, it was very hard and not moving at all and I was almost on the intersection, which always has heavy traffic with cars, 18 wheeler trucks and delivery trucks and more because its an industrial zone and Amazon and UPS are on this avenue along with other major companies. I could be involved and be responsible for a really bad crash if the light wouln't turn green on time. Fortunately it changed to the green light and I was in the very front. After this, I tried to go to the side if the road but there…”

“Unknown. When stopping then going to accelerate again the engine acts like it’s in nuetrual and revs the engine up then causing it to jerk forward. This happens at almost every stop.”

“The contact owns a 2011 Chevrolet Cruze. The contact stated that while driving at an undisclosed speed, the brake pedal was firm and difficult to depress. The vehicle was taken to the dealer and diagnosed as brake pump failure. The vehicle was not repaired and remained at the dealer, awaiting the brake pump part for replacement. The manufacturer was made aware of the failure and informed the contact that the vehicle was over the 100,000 miles warranty and that the recall for the brake pump had expired in 2018. The failure mileage was approximately 110,000.”

“I LEASED A 2011 CHEVY CRUZE AND HAD IT LESS THAN 1 MONTH. DEER WERE IN THE RD, SO I SLOWED DOWN, THEN BRAKES LOCKED, I WENT OVER AN EMBANKMENT INTO A LIGHTPOLE. TOTAL LOSS, TRANSPORTED VIA EMS TO MMMHC HOSPITAL, UNCONSCIOUS FOR HALF HOUR MY MEMORY IS NOW HORRIBLE, I HAVE BAD HEADACHES, MY BACK IS HORRIBLE AND IM WITHOUT A VEHICLE. I WASNT DRIVING ABOVE SPEED LIMIT. NO COLLISION WARNING AND I'VE BEEN TO ER AND MY DR MANY TIMES”