1997 Chevrolet Malibu steering problems

“1997 CHEVROLET MALIBU. CONSUMER WRITES IN REGARDS TO IGNITION SWITCH CUT OFF ISSUES. *TGW THE IGNITION SWITCH WAS REPLACED AT A COST OF $400.00 AND IS SEEKING REIMBURSEMENT. ALSO, THE OUTER AND INNER TIE RODS WERE REPLACED. *JB”

“I WAS DRIVING ON MY WAY HOME, AND I MADE A RIGHT TURN INTO MY NEIGHBORHOOD AND WHEN I BEGAN TO TURN LEFT INTO THE CURVE MY STEERING WHEEL WAS TURNING BUT MY CAR CONTINUED TO GO STRAIGHT INTO A NEIGHBOR'S YARD CAUSING ME TO SLAM ON BRAKES AND HIT A HILL! I GOT MY CAR CHECKED OUT THAT NEXT MORNING AND FOUND THAT IT WAS MY RACK AND PINION THAT HAS CAUSED THIS. I KNEW MY CAR HAD A RECALL SO I DECIDED TO SEARCH RECALLS FOR MY CAR (YEAR MAKE AND MODEL) I SAW WHERE THERE WAS A RECALL ON THE RACK AND PINION WHERE IF IT WENT OUT YOU WOULD NOT BE ABLE TO TURN LEFT ONLY RIGHT. I CONTACTED THE GM CORPORATE OFFICE AND STATED AS SUCH AND THEY SAID THAT WAS A RECALL BUT NOT ON MY SPECIFIC VIN # SO THERE IS NOTHING THAT COULD BE DONE. IS THIS POSSIBLE SEEMING AS THEY HAVE ISSUED A RECALL ON THIS PARTICULAR PART ALREADY ON 97 AND 98 CHEVY MALIBU'S? *TR”

“TL- THE CONTACT OWNS A 1997 CHEVROLET MALIBU. THE CONTACT WAS INCLUDED IN NHTSA CAMPAIGN ID NUMBER: 03V527000 (STEERING), RECEIVED THE RECALL REPAIR AND WEEKS LATER THE FAILURE RECURRED. THE CONTACT STATED THAT WHILE MAKING A TURN, EXTREME FORCE HAD TO BE APPLIED TO THE STEERING WHEEL AND THE VEHICLE WAS UNSTABLE TO DRIVE. THE VEHICLE WAS TAKEN BACK TO THE AUTHORIZED DEALER WHO REFUSED TO REPAIR THE VEHICLE. THE AUTHORIZED DEALER INDICATED THAT SOMEONE DAMAGED THE SUBFRAME AND BOLTS ALONG WITH THE QUARTER PANELS BEING RUSTED. THE VEHICLE WAS TAKEN TO AN INDEPENDENT REPAIR SHOP WHO INDICATED THAT THE AUTHORIZED DEALER NEEDED TO REPLACE THE BOLTS, SUBFRAME AND THE QUARTER PANELS WHICH WERE RUSTED. THE VEHICLE WAS TAKEN BACK TO THE AUTHORIZED DEALER PROVIDED AN INTERIM FIX OF WELDING THE BRACKETS TO THE FRAME AND WITHIN WEEKS THE COMPONENTS FRACTURED. THE VEHICLE WAS TOWED BACK TO THE AUTHORIZED DEALER FOR FURTHER INSPECTION, DIAGNOSIS AND REPAIR. THE BOLTS WERE BROKEN AND THE ENGINE WAS SITTING ON TOP OF THE STEERING RACK DUE TO THE FRACTURE. THE CONTACT WAS WAITING FOR APPROVAL FROM THE MANUFACTURER TO REMEDY THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE…”

“INTAKE MANIFOLD ON MY 1997 CHEVY MALIBU HAS STARTED TO GO BAD I KNOW ITS THE LOWER GASKET I CALLED CHEVY AFTER SEEING SO MANY OTHER PEOPLE WITH THE SAME PROBLEM I WAS TOLD CHEVY WOULD NOT REPLACE IT DUE TO IT BEING OVER TEN YEARS OLD WELL IT SEEMS LIKE WITH WAS A PROBLEM WAITING TO HAPPEN AS SOON AS THEY SEALED THE MANIFOLD AT THE FACTORY I THINK GM SHOULD REPLACE THIS ITEM ONCE FREE OF CHARGE PER CAR ALSO MY RACK AND PINION SEEMS TO STICK ON MY LEFT SIDE I'VE REPLACED THE POWER STEERING PUMP AND CHECKED THE RACK AND PINION SEEMS THE BALL BEARING WANTING TO COME OUT OR IS GONE I TOLD GM I DON'T THINK THEY REPLACED IT WHEN THEY RECALLED IT AND THEY TOLD ME THE FIRST OWNER DID BUT WONT SEND ME PAPERWORK ON THE REPAIR OR THE DEALERSHIP THAT DID THE WORK. *TR”

“I WAS DRIVING MY CAR ON THE BYWAY AND TOOK THE INTERSTATE MERGE LANE WHILE INCREASING MY SPEED TO MERGE INTO TRAFFIC I FELT A SNAP IN MY STEERING WHEEL AND GAS PEDAL, I THEN LOST THE DASH AND THE CAR IMMEDIATELY OVERHEATED, I HAD NO REAL POWER TO TURN THE WHEEL AND THE GAS PEDAL WAS A LOOSE PUSH. BEING THAT I HAD MERGED ONTO THE INTERSTATE WHEN THIS OCCURRED I HAD TO DRIVE AN ADDITIONAL 5 MILES TO THE NEXT EXIT. NOT EVERYONE HAS A CELL PHONE. WHEN I GOT TO THE NEXT EXIT I WAS ALMOST UNABLE TO TURN THE WHEEL ENOUGH TO GET IT INTO THE NEAREST PARKING LOT, IT WAS HARDER TO TURN THAN MY FIRST TRUCK A 1959 FORD TWIN I BEAM PICKUP. I FORTUNATELY DIDN'T HIT ANY ONE OR ANYTHING. UPON RAISING MY HOOD AFTER PARKING THE CAR I AM APPALLED TO SEE THAT THE TENSIONER PULLEY AND ONE OF THE IDLER PULLEYS ARE GONE AND MY SERPENTINE BELT IS SHREDDED. I HAVE REPLACED THE PARTS BUT SINCE THEN I ALSO FOUND THAT WITHIN 5 MILES THE "DREADED" GASKETS THAT SO MANY PEOPLE HAVE COMPLAINED ABOUT, AND MINE WE ALREADY EATING FLUIDS IN SIPPS BEFORE THIS, WERE GONE. I HAVE REPLACED THE BROKEN PULLEYS SERPENTINE BELT ALTERNATOR WATERPUMP AND GASKETS NOT A MONTH LATER THE OTHER IDLER PULLEY THAT…”

“TL*THE CONTACT OWNS A 1997 CHEVROLET MALIBU. THE CONTACT STATED THAT THE STEERING RACK AND PINION FAILS TO TURN PROPERLY. SHE COULD NOT EXPLAIN THE FAILURE ANY FURTHER; HOWEVER, IT IS THE SAME FAILURE STATED IN NHTSA CAMPAIGN ID NUMBER 03V527000 (STEERING:RACK AND PINION). THE SPEED WAS UNKNOWN. THE CURRENT AND FAILURE MILEAGES WERE 125,000.”