1997 Ford Crown Victoria engine and engine cooling problems

“WHILE DRIVING IN NJ, THE MANIFOLD BLEW AND MADE THE VEHICLE INOPERATIVE. LUCKILY, MY MECHANIC CAME AND TOWED THE CAR TO HIS GARAGE. THE MECHANIC PERFORMED A PRESSURE TEST AND DETERMINED THAT THE 'PLASTIC MANIFOLD' HAD BLOWN. THE ORIGIN OF THE FLUID LEAK WAS BEHIND THE ALTERNATOR. THEN WE DID SOME RESEARCH AND FOUND OUT THAT THIS WAS A PROBLEM BACK IN 2004-5. I NEVER KNEW, NOR WAS I NOTIFIED ABOUT THIS PROBLEM. I AM THE ORIGINAL OWNER OF THE CAR. THE CAR WAS JUST INTO THE FORD DEALERSHIP TO DIAGNOSE A "CHECK ENGINE" LIGHT ON, NO DISCUSSION WAS MADE ABOUT THIS MANIFOLD PROBLEM ... THEY EVEN CHECKED FOR ANY PREVIOUS TECHNICAL BULLETINS. SO, NOW WHAT HAPPENS?”

“I OWN A 1997 CROWN VIC LESS THAN 100 THOUSAND MILES. BOUGHT THE CAR 2 YEARS AGO AT DEALERSHIP IN LOUISVILLE KY. FOUND OUT THERE WAS RECALLS ON VEHICLE AFTER PURCHASE WAS TOLD CARMAX WAS GOOD. NOW HERE I SIT WITH A CRACKED INTAKE MANIFOLD WHICH WAS RECALLED, BUT NOONE EVERY FIXED IT. SOMEONE SHOULD BE RESPONSIBLE FOR THIS, YES WAS A RECALL SHOULDN'T THERE BE A LAW TO MAKE SOMEONE STAND BEHIND THE CRACK INTAKE MANIFOLD THIS WAS A 1 OWNER WHEN I BOUGHT IT WITH ONLY LIKE 60000 MILES,. *TR”

“I WAS DRIVING HOME FROM WORK AND THOUGHT A COOLANT HOSE HAD RUPTURED BUT AFTER HAVING THE VEHICLE TOWED TO MY MECHANIC'S PLACE OF BUSINESS WAS TOLD THAT THE INTAKE MANIFOLD HAD CRACKED AND REQUIRED REPLACEMENT. AFTER RESEARCHING I FOUND THAT FORD HAD ISSUED A RECALL FOR ONLY A FEW MODELS EVEN THOUGH MOST OF THEIR 8 CYLINDER 4.6 ENGINES UTILIZED THE SAME DEFECTIVE "COMPOSITE" INTAKE MANIFOLD. MY CROWN VICTORIA IS A 1997 WITH 60,000 ORIGINAL MILES! *TR”

“WHILE CHECKING THE OIL IN THE CAR, WE NOTICED A CRACK IN THE INTAKE. I WAS WONDERING IF THERE HAS BEEN A RECALL FOR THIS PROBLEM LIKE WITH THE FIREBIRD INTAKE RECALLS. *TR”

“INTAKE PLASTIC MANIFOLD CRACKED CAUSING LOSS OF COOLANT. VEHICLE HAD 67660 MILES ON IT. THIS IS THE SECOND CROWN VIC WE HAVE OWNED AND IT WILL BE THE LAST. THE FIRST ONE'S TRANSMISSION WENT OUT JUST AFTER THE WARRANTY RAN OUT. WE HAD TO BUY A SECOND CROWN VIC DUE TO THE STEERING MODIFICATIONS NECESSARY FOR MY WIFE TO DRIVE AND THE CROWN VIC IS THE ONLY CAR AT THE TIME THAT COULD BE MODIFIED TO THE NECESSARY STANDARDS. *TR”

“TL*THE CONTACT OWNS A 1997 FORD CROWN VICTORIA. WHILE DRIVING APPROXIMATELY 45 MPH, THE ENGINE WARNING LIGHT ILLUMINATED ON THE INSTRUMENT CONTROL PANEL. THE ENGINE THEN BEGAN TO OVERHEAT. THE CONTACT PULLED OVER TO FURTHER INSPECT THE VEHICLE AND NOTICED STEAM NEAR THE ENGINE. THE VEHICLE WAS TOWED TO A DEALER AND THEY STATED THAT BECAUSE THE INTAKE MANIFOLD WAS MADE OUT OF PLASTIC, IT FAILED. THE CONTACT WOULD HAVE TO PAY OVER $3,000 TO HAVE THE ENGINE REPLACED. THE VEHICLE HAS NOT BEEN REPAIRED. THE FAILURE AND CURRENT MILEAGES WERE 91,000.”