292 owner complaints to NHTSA about the 1998 Ford Explorer cite vehicle speed control, 14% of all 2,099 complaints for this model year. NHTSA also lists 4 recalls on this component.
“SPEED CONTROL GETS HOT TO TOUCH. ALL TOP FACING HAS MELTED OFF FROM HEAT. I WAS ON HIGHWAY AND MY STEERING WHEEL BECAME EXTREMELY HOT. MY SEAT WAS REPAIRED AFTER RECALL YEARS AGO. IT CONTINUES TO DROP LOW TO FLOOR.”
“GAS PEDAL BRACKET WELDING BROKE WHILE DRIVING AND GAS PEDAL IS NOW JUST DANGLING - CHECKED ON INTERNET AND THERE ARE A LARGE AMOUNT OF COMPLAINTS ABOUT SAME THING - SHOULD BE A RECALL”
“TL* THE CONTACT OWNS A 1998 FORD EXPLORER. WHILE THE VEHICLE WAS IN OPERATION, THE ACCELERATOR PEDAL BECAME DETACHED. THE CONTACT ACTIVATED THE HAZARD LIGHTS AND DROVE HOME WITH CAUTION. THE DEALER (PHIL LONG FORD AT CHAPEL HILLS, 1565 AUTO MALL LOOP, COLORADO SPRINGS, CO 80920, (719) 387-1099) WAS NOTIFIED, BUT COULD NOT DIAGNOSE THE CAUSE OF THE FAILURE. THE DEALER AND MANUFACTURER INDICATED THAT THERE WAS NO RECALL TO PROVIDE A REMEDY. THE CONTACT WAS UNCERTAIN THAT IF THE PART WERE REPLACED, THE FAILURE WOULD RECUR. THE FAILURE MILEAGE WAS NOT AVAILABLE.”
“WHEN I STEPPED ON THE GAS PEDAL AND STARTED TO PROCEED THROUGH AN INTERSECTION, I LOST ALL POWER AND HAD TO ROLL OR COAST VERY SLOWLY THROUGH THE INTERSECTION AND STOP ON THE OTHER SIDE IN A DANGEROUS POSITION IN TRAFFIC WHEN I COULD COAST NO FURTHER. THE GAS PEDAL BRACKET HAD COMPLETELY BROKEN OFF THE FIREWALL AND WAS LAYING ON THE FLOOR. THE BRACKET HAD BEEN ATTACHED BY THREE SPOT WELDS. SOME OTHER PEOPLE STOPPED TRAFFIC AND PUSHED ME TO A SAFE PLACE TO PARK. THE FORD DEALER PARTS' DEPARTMENT HAS NO PARTS TO FIX IT AND SUGGESTED WE BUY SOME BOLTS SOMEWHERE AND REATTACH IT OURSELVES SOMEHOW. TO COMPLETELY LOSE POWER WITHOUT WARNING WAS EXTREMELY DANGEROUS! THANK GOD I WAS IN A CONTROLLED INTERSECTION AND NOT TURNING LEFT ACROSS ONCOMING TRAFFIC OR IT COULD HAVE TURNED OUT MUCH WORSE. READING ONLINE BLOGS AND COMMENTS SHOWS THIS PROBLEM OF THE GAS PEDAL BRACKET FALLING OFF FORD PRODUCTS AND LOSING POWER IS NOT UNCOMMON.”
“WHEN ACCELERATING FROM A STOP, THE BRACKET THAT SUSPENDS THE ACCELERATOR PEDAL BROKE FREE FROM THE FIREWALL (IT WAS TACK WELDED IN SEVERAL SPOTS). THIS CAUSED AN IMMEDIATE LOSS OF POWER. LUCKILY I WAS LEAVING MY RESIDENCE WITH NO TRAFFIC BEHIND. IF I HAD BEEN ACCELERATING VIA ON RAMP TO HIGHWAY WITH VEHICLES RIGHT BEHIND ME MIGHT HAVE BEEN A DIFFERENT STORY. LOCAL GARAGE REPAIRED ($47.50) BY DRILLING HOLES AND REATTACHING WITH BOLTS. ACCORDING TO "SERIOUS EXPLORATIONS" USERS GROUP, NOT AN UNCOMMON PROBLEM. *TR”
“GAS PEDAL AND BRACKET HOLDING GAS PEDAL BROKE FREE OF IT'S MOUNTING LOCATION ON THE FIREWALL. 3 SPOT WELDS FAILED COMPLETELY. GAS PEDAL IS NOW DANGLING FROM ITS CABLE UNDER THE DASHBOARD. *TR”
Showing 6 of 292 reports. Read every report on NHTSA.gov.
FORD IS RECALLING MODEL YEARS 1995-2003 WINDSTAR, 2000-2003 EXCURSION DIESEL, 1993-1997 AND 1999-2003 F-250 SD THROUGH F-550 SD DIESEL, 1992-2003 E-150 THROUGH E-550, 1995-2002 EXPLORER, 1997 AND 2002 MERCURY MOUNTAINEER, 1995-1997 AND 2001-2003 RANGER, AND 1994 F53 VEHICLES EQUIPPED WITH THE TEXAS INSTRUMENTS SPEED CONTROL DEACTIVATION SWITCH (SCDS). THE SCDS MAY LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.
ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES EQUIPPED WITH 4.0L SOHC ENGINES AND STILL RETAIN THE ORIGINAL THROTTLE BODY (PART NUMBERS 97JF-9E926AB OR 97JF-9E926-AC). SOME OF THE ORIGINAL THROTTLE BODIES INSTALLED ALLOWED A GAP BETWEEN THE PLATE AND BORE TO BE BUILT TOO NARROW. THIS REDUCED CLEARANCE ALLOWED THE ENGINE DEPOSITS NORMALLY PRESENT IN THE THROTTLE BODY TO CONTACT OR BRIDGE THE GAP. IF THE ENGINE DEPOSITS BRIDGED THE GAP BETWEEN THE THROTTLE PLATE AND BORE AND THEN HARDENED, ON THE INITIAL APPLICATION OF THE ACCELERATOR PEDAL AFTER THE ENGINE HAS COOLED, THE OPERATOR WOULD NEED TO APPLY ADDITIONAL FORCE TO THE ACCELERATOR PEDAL TO BREAK THE BRIDGE.
VEHICLE DESCRIPTION: CERTAIN 1997-1999 RHD EXPLORER EQUIPPED WITH 4.0L OHV/SOHC ENGINES AND CRUISE CONTROL BUILT FROM MAY 29, 1996 THROUGH MARCH 4, 1999; 1998-1999 EXPLORER/MOUNTAINEERS EQUIPPED WITH 4.0L OHV/SOHC OR 5.0L ENGINES OR 1998-1999 RANGERS EQUIPPED WITH 2.5L, 3.0L FFV/EFI OR 4.0L ENGINES AND CRUISE CONTROL BUILT FROM JANUARY 5, 1998 THROUGH MARCH 4, 1999; 1998-1999 MUSTANGS EQUIPPED WITH 3.8L, 4.6L 2-VALVE OR 4-VALVE ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999; 1999 F250/F350/F450/F550 (OVER 8,500 LBS.) TRUCKS EQUIPPED WITH 5.4L OR 6.8L ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999; AND 1999 F-53 STRIPPED CHASSIS EQUIPPED WITH 5.4L OR 6.8L ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999. A CRUISE CONTROL CABLE CAN INTERFERE WITH THE SPEED CONTROL SERVO PULLEY AND NOT ALLOW THE THROTTLE TO RETURN TO IDLE WHEN DISENGAGING THE CRUISE CONTROL.
Complaints are unverified owner reports to NHTSA and are not normalized for sales volume. One complaint can cite several components.