2008 Ford Focus electrical system problems

“Ignition cylinder fails, leaving drivers stranded. Ford Focus online forums are plastered with numerous complaints about the focus ignition lock cylinder failure, and there are youtube videos showing how to repair it with tape or rigging a bypass push button ignition switch, but FORD should be fixing these issues so people are not stranded. Issue does not happen when driving, and only happens when key is off, and attempting to crank the car. Several people have complained about 500 dollar repairs that only last a few months before issue returns, and ford is very aware, but there are no recalls for the defect. I suppose a car that wont start is not considered dangerous, in itself, but the "hacks and fixes" for the issue can potentially be, and I think this deserves extreme scrutiny, as it affects several ford year models. drivers can suddenly be stranded miles from home and stuck with expensive repair costs that can render them without any transportation at all with no means of resolution.”

“MY IGNITION SWITCH IS GETTING STUCK AND IT IS NOT ALLOWING ME TO TURN ON THE CAR. IT IS HARD TO TURN ON MY VEHICLE. THE CATALYTIC CONVERTER IS MARKING ON MY CHECK ENGINE LIGHT, IT ISN'T ALLOWING MY VEHICLES MOTOR TO VENT OUT.”

“CONSTITUENT WRITES IN REGARDS TO SWITCH ASY IGNITION FAILURE ON 2008 FORD FOCUS. *LD THE CONSUMER REQUESTED TO BE REIMBURSED FOR THE COST OF THE REPAIRS FOR THE IGNITION ASSEMBLY. *JS”

“TL* THE CONTACT OWNS A 2008 FORD FOCUS. THE CONTACT EXPERIENCED DIFFICULTY INSERTING THE KEY INTO THE IGNITION IN ORDER TO START THE VEHICLE. THE CYLINDER IN THE IGNITION WAS REPLACED, BUT THE FAILURE RECURRED. THE IGNITION SWITCH WAS REPLACED, BUT THE FAILURE RECURRED A THIRD TIME. THE IGNITION WAS REPAIRED BY AN INDEPENDENT MECHANIC WHO INSTALLED A PIECE OF CARDBOARD IN ORDER TO START THE VEHICLE. THE DEALER AND MANUFACTURER WERE NOT CONTACTED. THE FAILURE MILEAGE WAS 104,000.”

“TL* THE CONTACT OWNS A 2008 FORD FOCUS. THE CONTACT STATED THAT THE KEY FAILED TO TURN IN THE IGNITION SWITCH. INITIALLY, THE KEY HAD TO BE PUSHED DOWN FOR IT TO TURN AND START THE VEHICLE. CURRENTLY, THE CONTACT HAD TO UNLOCK THE STEERING WHEEL AND WIGGLE IT UNTIL THE KEY TURNED AND STARTED THE VEHICLE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC TO BE DIAGNOSED, BUT NO FAILURE CODE WAS FOUND. THE CONTACT CALLED FIRST FORD (LOCATED AT 292 WILLIAM S CANNING BLVD, FALL RIVER, MA 02721, (508) 730-1000) AND WAS INFORMED TO SCHEDULE AN APPOINTMENT. THE VEHICLE WAS NOT TAKEN TO A DEALER AND WAS NOT REPAIRED DUE TO THE DIAGNOSTIC AND REPAIR FEES. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 167,845.”

“WHEN I PUT KEY IN IGNITION MOST TIMES IT DOESNT CATCH AND CAR DOESNT TURN ON. I HAVE TO PUSH HARDER TO CRANK CAR ON OR TAKE KEY OUT SEVERAL TIMES AND KEEP TRYING UNTIL IT CATCHES. SOMETIMES WHEN I PULL KEY OUT PART OF IGNITION SWITCH PULLS OUT A LITTLE AND CAR VEGINS TO CHIME UNTIL I PUSH IGNITION SWITCH BACK IN. I KNOW THERE WAS A SIMILAR RECALL UNTIL THE 2005 MODEL, THIS ISSUE WAS NEVER FIXES FROM ALL THE RESEARCH IVE DONE ON THIS ISSUE”