2017 Hyundai Santa Fe electrical system problems

“Odometer Fraud. The contact purchased a 2017 Hyundai Santa Fe. It was discovered that there was a mileage discrepancy. The vehicle was a dealer sale. At the time of the purchase, the mileage was 45,000. However, when the vehicle was taken to a dealer for a trade-in, it was discovered via a Carfax report that the mileage was over 109,000.”

“On [XXX], Laguna Niguel Hyundai performed Service Campaign 9C2 (ECU software update for Theta II emissions improvement, Hyundai TSB 26-01-013H) on my 2017 Hyundai Santa Fe Sport. Immediately after the update, the vehicle developed drivability problems that did not exist before: rough/harsh shifting, hesitation, and loss of power during cold-start operation (the first 1-3 minutes after engine start), plus intermittent infotainment and navigation system failures. Hyundai's own dealer notice dated 05/18/2026 acknowledges vehicles may exhibit 'hesitation or rough shifting' after the 9C2 update and states the matter is 'currently under review' — no permanent fix has been released. The dealership that performed the recall has since refused to service my vehicle again. I opened case #[XXX] with Hyundai corporate; my inquiries on 09/03/2026, 09/11/2026, and 09/17/2026 asking for a corrective action have gone unanswered. The hesitation and power loss are a safety hazard when merging into traffic or crossing intersections. I request NHTSA investigate this pattern.”

“Was driving down road car went into limp mode about caused a big wreck, check engine was flashing and heard a loud noise as I was trying to get to safety. Had the car scanned and was for code p1326 and looking at all the recalls nothing is for the 2.4l but y'all have been having a lot of issues with these theta 2 engines.”

“Cold-Start Hesitation & Rough Shifting: Following the 9C2 ECU update, my vehicle is experiencing a brief period of throttle hesitation, rough shifting, or jerky transmission behavior specifically during cold-start operations.”

“My 2017 Hyundai Santa Fe, purchased new from Lynnes Hyundai in February 2017, has approximately 93,000 miles. The vehicle previously developed a significant oil-consumption/engine problem that was diagnosed by Hyundai, and Hyundai replaced the engine with a remanufactured engine. Approximately two weeks after the engine replacement, the check-engine light illuminated and DTC P1326 was identified. The dealership replaced the knock sensor. Approximately two weeks later, the check-engine light illuminated again with a recurring P1326 condition. The vehicle is currently at Lynnes Hyundai and has been there approximately three weeks while they attempt to determine the cause. Hyundai Techline is involved. Prior to the current repair visit, while traveling approximately 60 mph, the vehicle experienced a very forceful hesitation that jerked the vehicle. I immediately slowed down and pulled onto the shoulder. The vehicle continued to hesitate intermittently while I drove slowly to safety. I was concerned that the vehicle could lose power or shut down while I was driving at highway speed, creating a risk of a crash. The recurring P1326 condition has been confirmed by the…”

“Airbag light on. La Quinta Hyundai verified light on scanned codes found active b134800 Driver airbag resistance circuit short to ground 1st stage. Testing found clock spring issue internal fault. Since this clock spring is related to driver airbag, & horn, it would seem that this would be a safety hazard that would be under warranty. The extended warranty (Z01) that I received from Hyundai doesn’t cover my problem.”