2023 Hyundai Tucson problems

“While backing out of driveway, with parked vehicle along side and one moving vehicle in the road, I was applying the break and the Emergency Stop feature activated. My speed was 2-3 MPH and slowing.”

“SAFETY DEFECT SUPPLEMENT TO NHTSA COMPLAINT #11685540 | VIN: [XXX] | MILEAGE: 27,370 ​This filing supplements Complaint #XXX regarding an uncorrected, compounded steering safety failure following the catastrophic detachment of the steering column while driving on XXX (Repair Order #XXX). ​COMPONENTS FAILED: Steering column assembly, footwell closeout shield, dashboard lower crash pad structural frame, and push-start switch. All components and vehicle are available for immediate inspection. ​SAFETY RISK: Following an invasive warranty teardown for an ignition switch failure under R/O #XXX at [XXX] Hyundai, the vehicle was released in an incomplete, hazardous condition. The factory lower footwell closeout shield was completely omitted, leaving the rotating intermediate steering shaft, universal joint, electric power steering motor, brake clevis linkage, and wiring harness fully exposed directly above driver foot controls. This creates a severe entrapment and mechanical binding hazard. An unauthorized exterior screw was drilled directly through the finished lower crash pad trim to pinch broken internal plastic tabs together, and hardware was left rattling inside…”

“The vehicle developed an intermittent but potentially dangerous engine control malfunction. After the engine reached normal operating temperature, the engine speed (RPM) would repeatedly surge while the vehicle was stopped in Park and Neutral, fluctuating from approximately 1,000 RPM to over 3,000 RPM without any throttle input from the driver. The condition occurred with the air conditioning turned off and could be reproduced multiple times. At approximately the same time, the Auto Start/Stop system stopped functioning and displayed a warning indicator. A malfunction indicator lamp (check engine light) also appeared during the incident. The warning light later turned off, but the engine surging continued. This unexpected increase in engine speed raises concerns about unintended vehicle movement or loss of driver control if the condition were to occur while shifting into gear or while driving. The unpredictable nature of the malfunction presents a potential safety risk to the occupants of the vehicle and to others on the road. The vehicle has been taken to an authorized Hyundai dealership for diagnosis and repair and remains under inspection. The problem is…”

“2023 Hyundai Tucson Limited, 2.5L GDI, Alabama-built (VIN 5NMXXXXXXXXXXXXXX), built [XXX]. On [XXX], at about 37,550 miles, the check engine light came on flashing and the engine ran rough while I was traveling in Canada. My scan tool showed P0300, P0302 and P0304 (misfires on cylinders 2 and 4). On July 6, 2026, Experience Hyundai in Charlottetown, PE (service order 92XXX) replaced one ignition coil under warranty. No fuel injector leak test was performed. The misfires returned. On [XXX], at 39,409 miles, my scan showed P0302 active and P0304 pending. The car also had extended cranking after sitting and the check engine light was on. I was told I could keep driving the car unless it started to jerk or engine light started to flash, then immediately stop driving it and have it towed. On September 25, 2026, the car was towed to McGovern Hyundai Route 2, Leominster, MA (invoice 148XXX). The dealer found all 4 fuel injectors leaking and replaced them under warranty with injector service kit 35399-2S133QQH. My vehicle is outside the production range of Hyundai TSBs 23-FL-002H-1 and 26-FL-001H, which cover this injector failure only for Alabama-built Tucsons…”

“I was on the highway on the way to work when my car started stalling. Every time I pressed the gas to give it some power, it would not go anyway where. after getting it towed to get looked at some of the fuel injectors failed and were misfiring. The warning message about ‘check engine’ popped up 2 minutes before it happened. this is the third time now in less than 6 months.”

“While driving on a highway shortly after taking delivery of this vehicle as a Certified Pre-Owned purchase from an authorized Hyundai dealership, I experienced sudden and total brake failure. The Electronic Parking Brake (EPB) warning light illuminated and an audible warning chime sounded. The brake pedal did not respond normally. I was unable to slow the vehicle with the brakes and was forced to make an emergency maneuver to exit the highway and come to a safe stop. Upon inspecting the vehicle after stopping, I discovered that the rear left brake caliper had completely detached from its mounting bracket. The caliper was on the ground beneath the rear of the vehicle. Brake fluid had leaked onto the road surface. The vehicle had been in my possession for less than one full drive since purchase. As part of the CPO certification, the selling dealer performed a multi-point inspection and documented installation of new brake pads and certified the brake system as in good working order. The detachment of the caliper is consistent with mounting bolts that were either not reinstalled or not properly torqued following the dealer's brake service during CPO preparation. I…”