2015 Jeep Cherokee electrical system problems

“Online is saying there is 0 recalls after a year of having the vehicle a recall was sent by mail. I got it fixed by jeep van nuys, the engine and the other equipment attached looks unsafe and it is completely overheating”

“The contact owns a 2015 Jeep Cherokee. The contact stated that on multiple occasions, the brake pedal became inoperable and felt spongy while attempting to stop the vehicle. The contact also stated that the steering wheel became difficult to operate, and a crunching sound was heard while turning the steering wheel. Additionally, the contact stated that multiple incorrect warning messages illuminated on the instrument panel, including the Start/Stop warning message and a door open warning message. The contact stated that the failures began after the vehicle had been repaired under a tailgate recall. The vehicle was taken to another dealer. The vehicle was not diagnosed or repaired. The dealer advised the contact to return to the previous dealer for repairs. The manufacturer was made aware of the failure. The failure mileage was approximately 118,600.”

“I was driving and going around the roundabout and I got an error message service shifter & park, reverse, neutral, drive, and drive minus or negative which is the manual part all lit up. I took it to the dealer and they said it would have to be examined, but I went online and found out between 2014 and 2018 of these vehicles, this is something that happens frequently. I don’t understand why it’s not a recall.”

“The car continues to have an issue with the same recalls that were priorly fixed but continued to happen after a few years. The last repair for this recall only lasted six months and I now need to replace the exact same parts again. The vehicle is completely faulty. The computer control valve for the transmission continues to fail. My vehicle will say service transmission, and then you cannot switch gears and becomes undrivable until you clear the codes or replace the parts.... again.”

“The Vehicle suddenly stopped and I was unable to brake or steer the wheel while driving (loss of power/limp mode). I took it to a shop who ran a diagnostic and it came back as DTC code. I now had to tow it out of pocket to the nearest dealership.”

“After learning of the recall for the lift gate module because of water intrusions of multiple points. The wiring harness to the lift gate module was serverly corroded and had to be replaced. The original fix, without the corrosion on the harness, was the place a piece of plastic over the module. That recall and fix did nothing to address the issues of multiple points of water intrusions. From body seems, the seal around the hatch, and around the tail light(s). There is more than one harness, and more than one module in the tire well. The multiple water leaks, that can and have affected an electrical component the was deemed as being a potential to start a fire, and none of the others in there are. There needs to be a recall on the water leaks, from their poor design! I have saw first hand how badly the harness they HAD to replace, along with the lift gate module. Because of the very seriousness of the corrosion. Where they not only replaced both of them, but also had to relocate the lift gate module, because of the evidence of the amount on water that has been entering the cargo, and wheel well areas! À 11 year old vehicle, from the information I have read up…”