2010 Jeep Wrangler service brakes problems

“My vehicle has experienced a complete failure of the ABS Control Module. A dealer diagnosis confirmed internal module failure. The symptoms are: - All ABS system warning lights illuminated (ABS, traction control, brake, sway bar) - Odometer and speedometer stop working while driving - All brake lights remain on continuously - Vehicle exhibits erratic shifting / rough braking This is a documented safety defect affecting many Chrysler/Dodge/Jeep owners where the dealer confirms the ABS module is defective but cannot repair due to the part being on national backorder with no ETA. I am being told the part is backordered indefinitely. I am left driving an unsafe vehicle with no functioning ABS, stability control, or accurate speed/odometer reading, or parking a vehicle I am still paying for and insuring. I am formally requesting: 1. Immediate provision of a replacement ABS module, or a loaner/rental vehicle at FCA's expense until repair”

“Most of the dash lights are on scan code U1412. Says traction control not working, ABS not working, speedometer not working, and airbags not working. The Power Control Module (PCM) needs replaced. A known issue with the Jeep Wrangler JKs. No one stocks the parts and used ones are way over priced. How can Jeep not have to replace it or at least stock a replacement part that has the issues resolved?”

“ABS Module fails with C2200 code. No replacement parts are available, hence driving with no ABS (manual brakes). Jeep needs to address the nationwide backlog on ATS moudles so proper repairs can be made and Jeep owners have the peace of mind that the ABS is functioning properly.”

“ABS Module failure. Unable to get replacement. Manufacturer refuses to provide & unable to use used ones due to being programed to Vin#. It has been over 2 years and no resolution in site.”

“The ABS control module is reporting a DTC code C2200 indicating an ABS module internal failure. The instrument panel warning lights for esp, bas, abs and the traction control are all continuously lit. This problem is continuous but has not been confirmed or inspected by a dealer. independent service center, police or insurance representatives. It is, however, a well known issue reported on Jeep owner forums as an ABS Dashboard Christmas Tree. I have not yet had an ABS related accident but it is extremely concerning that there is an internal ABS module failure that could cause an accident. I have attempted to replace the ABS Module, part 68067458AA, but I am told this part is not available due to a hold for engineering review. I was told the engineering review should be completed by March 20 but until then I am unable to obtain a new replacement part.”

“When starting the vehicle the check engine light comes on. Including the low tire pressure sensor comes on. The tires have been repaired yet the pressure system still says low. The car when shortly after it's been turned on only going several miles an hour and staying about 2RPMs starts to kick forward in a abrupt motion as if it wants to accelerate. Sometimes it's a hit or miss to start the car so I have to put it in neutral to start it. In conclusion everytime the vehicle starts to move from a complete stop or braking a loud clanking noise repeats a 2-3 times (clank,clank,clank) continues then stops after driving continually, then repeats after every stop that is made. I'm not sure what to make of it but my guess it has to do with the braking system even though no warning lights for brakes have come up.”