1999 Mazda 6 Series recalls

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Risk: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK, SEDAN, WAGON, BRAT, DL, GL, GL-10, RX, XT, AND XT6 PASSENGER VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. CERTAIN SPX FILTRAN FUEL FILTERS WITH A 90-DEGREE ANGLE INLET TUBE, MODEL 800F300-S2, SOLD AS REPLACEMENT FILTERS FOR 19983-1994 SUBARU VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. FUEL MAY LEAK FROM THE FILTER DUE TO NON-CONFORMING BRAZING WELDS WHERE THE INLET TUBE IS CONNECTED TO THE FILTER CAN.

Risk: IN THE PRESENCE OF AN IGNITION SOURCE, A VEHICLE FIRE CAN OCCUR.

Remedy: SPX WILL NOTIFY ITS CUSTOMERS AND PROVIDE A FULL REFUND. THE RECALL BEGAN SEPTEMBER 27, 2005. OWNERS MAY CONTACT MR. CHRIS GREESON AT 704-869-3733 OR CONTACT THE WIX INFORMATION HOTLINE AT 800-949-6698.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN EXTERNAL SPRING IN THE TIMING BELT TENSIONER COULD BREAK.

Risk: THE BROKEN SPRING MAY GET CAUGHT IN THE TIMING BELT, RESULTING POSSIBLE ENGINE STALLING.

Remedy: DEALERS WILL CHECK THE TENSIONER INSTALLED AND REPLACE IT IF THE VEHICLE IS EQUIPPED WITH THE AFFECTED TENSIONER.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. CERTAIN RESERVOIR TANK CAPS ON THE BRAKE MASTER CYLINDER WERE PRODUCED WITH A WORN OUT DIE AND LACK VENTILATION HOLES. AS A RESULT, THE PRESSURE IN THE RESERVOIR TANK CAN DROP GRADUALLY AS THE BRAKE PAD OR SHOE WEARS AND AMBIENT TEMPERATURE DROPS. ALSO, THE PRESSURE COULD REACH A POINT THAT THE BRAKE CALIPER AND DRUM CYLINDER ARE PULLED BACK BY THE VACUUM IN THE RESERVOIR TANK WHEN THE VEHICLE IS PARKED FOR A LONG TIME.

Risk: THIS CONDITION COULD CAUSE REDUCED BRAKE EFFICIENCY, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE RESERVOIR CAP AND REPLACE IT, IF NECESSARY.