2001 Mitsubishi Eclipse structure problems

“1. EVERY TIME IT RAINS THERE IS A LARGE ACCUMULATION OF WATER LEAKING FROM FRONT WINDOW/FRONT VENTS EVERY RAINFALL ON FRONT FLOOR BOARDS; 2. EVERY RAINFALL, SOAKS CARPET FLOOR BOARDS THROUGH TO BOTTOM FRAME OF CAR; 3. MANY, MANY THICK TOWELS ON FRONT FLOOR BOARDS. *TR”

“I'VE PREVIOUSLY OWNED 2 ECLIPSES W/ NO PROBLEMS, THIS ONE HOWEVER HAS BEEN NOTHING BUT A LEMON. 2001 MITSUBISHI ECLIPSE GT V6. IN ADDITION TO THE CLUTCH WHICH HAD TO BE REPLACED 1 YR AFTER WARRANTY EXPIRED, I HAVE HAD AN ABUNDANCE OF PROBLEMS W/ PARTS THAT SHOULD NEVER NEED TO BE REPLACED, NONE HAVE BEEN COVERED BY WARRANTY. I HAVE REPLACED EVERY SWAY BAR TWICE, THE A/C FAILED, THE ANTENNA EMBEDDED IN THE REAR WINDOW FAILED, ONE OXYGEN SENSOR, THE MIDDLE REAR BRAKE LIGHT WIRING BROKE, 2 CATALYTIC CONVERTERS FAILED. AND THE WORST IS I WAS GOING THROUGH A HEADLIGHT A MONTH ONLY TO DISCOVER THAT THE HEADLIGHTS HAD ACTUALLY MELTED THE TO THE CONNECTORS ON BOTH SIDES! AND NOW I MAY HAVE AN ELECTRICAL FAULT OR FAULTY VALVE IN MY A/C UNIT CAUSING MY HEAT TO KICK ON WHEN THE A/C IS TURNED ON. *TR”

“DASH CRACKED IN HALF (DEGRADATION). I FOUND THAT THIS IS HAPPENING TO ALMOST EVERYBODY WITH THE MITSUBISHI ECLIPSE (MINE IS A 2001). MITSUBISHI WILL NOT ADDRESS THIS PROBLEM. THIS NEEDS TO BE A RECALL. *TR”

“I HAVE A 2001 BLACK ECLIPSE GT...BOUGHT BRAND NEW IN JAN. 01. AT 43,000 MILES ALL TOP SURFACE AREAS WERE SHOWING SIGNS OF PAINT PULLING FROM THE PRIMER...AT 53,000 MILES THE ROOF WAS DOWN TO THE METAL...TOOK ME MONTHS TO GET MITS. TO HANDLE. THEY ONLY WOULD PAINT THE AFFECTED SURFACES? THEN 20,000 THE REST OF THE SURFACES BECAME AFFECTED. I TOOK IT TO THE DEALER AND SAID THEY WERE NOT COVERING THESE ISSUES ANYMORE??IF IT WAS ESTABLISHED AS A DEFECT IT SHOULD BE COVERED. *TR”

“BODY PAINT ON HOOD AND TRUNK ARE DETERIORATING TO THE POINT THAT THERE ARE HUGE WHITE PATCHES SHOWING THROUGH THE BLACK PAINT. THE VEHICLE HAS BEEN WASHED AND WAXED AT LEAST ONCE A MONTH FOR THE PAST 6 YEARS. THE PAINT WAS OBVIOUSLY DEFECTIVE WHEN IT WAS APPLIED TO THE VEHICLE IN THE FACTORY. I CONTACTED MITSUBISHI AND THEY DECLINED TO TAKE ACTION. *TR”

“I. THE EVENTS LEADING UP TO THE FAILURE ARE: 1. I WASHED AND WAXED MY CAR ON A REGULAR BASIS. 2. I DROVE MY CAR ON THE HIGHWAY AT A SPEED OF APPROXIMATELY 70 MILES PER HOUR. *TR II. FAILURE AND ITS CONSEQUENCES: 1. THE PASSENGER SIDE MOLDING ON THE FRONT WINDSHIELD OFFICIALLY CALLED THE A PILLAR SEPARATED FORM THE BOLTS WHICH HELD IT TO THE FRAME OF THE CAR AND FLEW OFF STRIKING AND DENTING THE PASSENGER DOOR. 2. THE BOLDS THAT HELD THIS MOLDING TO THE FRAME ARE STILL ATTACHED TO THE CAR SHOWING THAT THERE WAS A BREAKDOWN OF THE ADHESIVE MATERIAL THAT ORIGINALLY HELD THIS PART TO THE BOLTS. III. WHAT WAS DONE TO CORRECT THE FAILURE? NOTHING 1. AFTER GOING TO THE DEALER, THEY CONTACTED THE FACTORY REPRESENTATIVE, NOTHING WAS DONE. 2. AFTER SPEAKING TO A CUSTOMER SERVICE REPRESENTATIVE FROM MITSUBISHI MOTORS OF NORTH AMERICA, NOTHING WAS DONE. 3. AFTER WRITING TO THE PRESIDENT OF MITSUBISHI MOTORS OF NORTH AMERICA ON SEPTEMBER 24, 2007, I HEARD NOTHING. 4. ON OCTOBER 8, 2007, I SENT A SECOND LETTER TO THE PRESIDENT OF MITSUBISHI MOTORS OF NORTH AMERICA AND MEMBERS OF THE BOARD OF DIRECTORS. I COINCIDENTALLY RECEIVED A CALL FROM THE CUSTOMER SERVICE REPRESENTATIVE…”