2020 Toyota Corolla power train problems

“What component or system failed or malfunctioned: complete slave cylinder failure resulting in loss of braking and ability to shift. Luckily I was traveling at a low rate of speed when this happened, but if this happens to anyone on the freeway or while turning against traffic for example they would have no control of their car and could be seriously injured. I took it to the dealership and they diagnosed it as a slave cylinder failure at only 70k miles. This is incredibly pre-mature. The vehicle has not been inspected by the manufacturer, only the dealership but I am trying to escalate the issue. No warnings at all, I regularly get my car serviced on there were no instances of the clutch acting strange or brakes losing power (because the clutch and brakes share the same fluid reservoir) prior to this incident.”

“The concentric slave cylinder in my vehicle is a big issue with these cars. There has been so many reports of issues happening with these cars manual transmission Corolla's. This can cause fluid to spew, brakes to stop working, and no longer able to drive the vehicle safely. This part should be recalled and covered by Toyota.”

“The CV joint, there is a clicking sound when sharp turns are make to include U-turns. Spoke with a mechanic and was instructed to reach out to the dealership and check for recall on it. I did see any but I see a Technical Service Bulletin ( TSB-0106-20) for 2015- 2021 Corolla models regarding a potential clinking noise during sharp turns and u turns. This may have started three months ago. It is more noticeable now that I am driving more.”

“FAILED COMPONENT & AVAILABILITY: The manual transmission Concentric Slave Cylinder (CSC) failed internally. Due to caustic hydraulic fluid contamination and severe system pressure loss, I had to replace the internal CSC unit, the clutch disc, the pressure plate, the flywheel, the master clutch cylinder, and the hydraulic clutch lines. The failed components have been retained and are available for inspection upon request. SAFETY RISK: The plastic housing of the OEM slave cylinder cracked internally, spraying caustic hydraulic brake fluid inside the transmission bell housing and completely coating the flywheel, pressure plate, and clutch friction disc. This caused an immediate, sudden loss of hydraulic pressure, forcing the clutch pedal to drop and stick flat to the floorboard. This put my safety and the safety of others at extreme risk, as it suddenly prevented me from disengaging the clutch, shifting gears, or safely dropping the vehicle into neutral while driving in active traffic.CONFIRMATION & REPAIR: A certified Toyota dealership diagnosed the issue and issued an unaffordable repair estimate of $4,800 to fix this recurring manufacturer defect. Because of…”

“Design issue: The 12th-generation (E210) Corolla manual transmission utilizes a CSC unit containing plastic/ABS components that owners and forum communities frequently cite as a weak point prone to premature leakage and mechanical failure. This occured to my corolla on a roadway and presented a severe safety hazard.”

“The contact owns a 2020 Toyota Corolla. The contact stated that while driving at an undisclosed speed, the clutch failed to operate as intended. The contact stated that the clutch seized, and the RPM increased. No warning lights were illuminated. The vehicle was taken to the dealer; however, the failure was not duplicated. The contact stated that the failure reoccurred. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 90,330.”