2013 Toyota Prius C electrical system problems

“While I was driving on the freeway the dash lit up with multiple lights. Simultaneously, I lost power to the car and could not accelerate and only break. The steering was tight and I could not steer correctly. Then a message that said, CHECK HYBRID SYSTEM STOP THE VEHICLE IN A SAFE PLACE IMMEDIATELY. The was slowing down and I had to pull over on the side of the freeway. There were no fluids leaking from the car.The car did not power back on nor run for over 10 minutes. The incident put my safety and other safety at risk by turning off while driving highway speeds. I was afraid for my life. There is an open recall which has not yet been resolved Major Safety Recalls for the 2013 Prius •The Hybrid Inverter Module (Critical Recall): Excessive voltage inside the Intelligent Power Module (IPM) can cause the hybrid system to overheat, shut down completely, or put the car into "limp home" mode while you are driving.”

“My 2013 Toyota Prius has a failed inverter/converter assembly, including the Intelligent Power Module (IPM). This component is critical for vehicle operation and designed to last the life of the car. Premature IPM shorting and inverter failure is a known defect acknowledged by Toyota through multiple recalls and service campaigns for other VINs with the same part number. My vehicle is giving codes P0A94 and P0A1A which are also listed in the recalls for other Prius models of similar age. My vehicle experiences the same failure, yet Toyota has denied goodwill coverage, claiming “insufficient service history.” Routine maintenance like oil changes and brake inspections does not affect this component, making the denial unreasonable. There is nothing to service on the inverter. This defect poses a serious safety risk, sudden inverter failure caused total loss of power while driving and loss of power steering, it was difficult to pull my car off the road. This poses a danger to drivers, passengers, and others on the road. Toyota’s exclusion of my VIN from coverage leaves me financially responsible for a known safety defect. I request NHTSA to investigate Toyota’s…”

“While driving on Highway 316E on March 31, 2022, at approximately 10am, at some point, as traffic started to slow down and I applied my brakes I was dumbfounded when my car would not stop! It was frightening, as I watched my car get closer and closer to the large truck in front of it. I kept applying the brake and then pumping the brake. The brakes kept failing and had no pressure or tension in them to stop the car. The brake pedal was flat on the floor. But, thanks to a sufficient distance between my car and the truck in front of it, it rolled to a stop just short of crashing into the back of said truck by an inch or two. Sometime in October of 2024 , I spoke with a Service Rep at Marietta Toyota about a whizzing sound that appeared to be coming from under the hood on the driver’s side. This sound would occur while I was driving and even when I turned the car off. It would continue making this whizzing sound sometimes for as long as 45 minutes after the ignition was turned off. I took the car back to Marietta Toyota and the service rep said the problem was related to the weather. On December 24, 2024, at around 11:00am EST, I parked my car in the parking lot…”

“The brake booster assembly (part number 47070-47060) on my 2013 Toyota Prius has failed. This component is critical to the proper functioning of the braking system. It is currently still installed in the vehicle and available for inspection upon request. As a result of the failure, the ABS warning light, traction control light, and brake warning light are all illuminated on the dashboard. The braking performance has noticeably declined — the pedal feels inconsistent and at times unresponsive. This has created a significant safety risk while driving, especially during sudden stops or in wet conditions, as it compromises the vehicle's ability to brake efficiently and predictably. The issue has been confirmed by a Toyota dealer (or independent mechanic if that’s the case — feel free to change this line accordingly). The dealer diagnosed the issue as a failure of the brake booster assembly, which aligns with known failures reported by many other 3rd-generation Prius owners. The vehicle has not been involved in an accident, and has not been inspected by the police or insurance representatives. Toyota previously issued a Customer Support Program (CSP ZJB or ZG1)…”

“Immobilized failure due to combination of brake hose failure preventing hybrid control/shift actuator. Hybrid steering lock became disengaged and could not communicate with the certification ecu due constant power being disabled due to complete main body failure. Hybrid system cannot go back into park however ecm side did. Ecm was not receiving power as dealer coded main body as a plug in hybrid effectively disabling fuel systems (including emissions/fuel safety) causing full misclassification in the smart key certification process. Car starts, goes into ready and disables LIN comms alongside cutting main relay due to tailgate and fuel constant powers being cut while driving.”

“While driving on the highway, ABS, "Brake"/E-Brake, Traction Control Lights lit up all at the same time out of the blue. No prior engine lights/codes before this incident. During that trip, brakes felt more difficult to press, loss all brake regeneration for the hybrid battery but was still about to brake for that entire 100 miles trip. As of now, the car is still able to brake but it looks like it's just primarily using the mechanical brakes all the time now. It still has that different brake feel compared to when before all those engine lights went on. Regenerative braking is no longer working. Brought the car to the shop at was given the error codes C1391 and C2315.”