1996 Volvo 8 Series recalls

ON CERTAIN PASSENGER VEHICLES, AFTER PROLONGED EXPOSURE TO HEAT, THE FUEL TANK MAY SEEP OR LEAK FUEL AT THE POINTS WHERE THE HEAT SHIELD IS ATTACHED.

Risk: FUEL LEAKAGE, IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN A FIRE.

Remedy: VOLVO WILL INSPECT THE FUEL TANK AND REPLACE IT IF ANY EVIDENCE OF FUEL SEEPAGE OR LEAKAGE IS FOUND. ALL VEHICLES WILL RECEIVE NEW REINFORCEMENT BUSHINGS AT THE HEAT SHIELD ATTACHMENT POINTS TO PREVENT FUTURE LEAKS. THIS RECALL WILL BE CONDUCTED AS A SAFETY RECALL IN THE HOT WEATHER STATES OF ALABAMA, ARKANSAS, ARIZONA, CALIFORNIA, FLORIDA, GEORGIA, HAWAII, LOUISIANA, MISSISSIPPI, NEVADA, NEW MEXICO, NORTH CAROLINA, OKLAHOMA, SOUTH CAROLINA, TENNESSEE, TEXAS, AND UTAH, AND AS A SERVICE RECALL IN THE OTHER 33 STATES AND THE DISTRICT OF COLUMBIA. THE RECALL BEGAN ON SEPTEMBER 24, 2004. OWNERS MAY CONTACT VOLVO AT 1-800-458-1552.

ON SOME SEDANS AND STATION WAGONS EQUIPPED WITH SEAT HEATERS, IT IS POSSIBLE THAT EXCESSIVE COMPRESSION OF THE SEAT CUSHION COULD CAUSE DAMAGE TO THE ELECTRICAL WIRING OF THE SEAT HEATER.

Risk: IF THIS OCCURS, THE DAMAGE COULD RESULT IN A SHORT CIRCUIT THAT COULD CAUSE A FIRE.

Remedy: DEALERS WILL DISCONNECT THE EXISTING WIRES AND INSTALL A NEW ELECTRONIC THERMOSTAT AND CABLE HARNESS. OWNER NOTIFICATION BEGAN ON FEBRUARY 19, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO AT 1-800-458-1552.

ENGINE BLOCK HEATERS INSTALLED AS ACCESSORIES. THE BLOCK HEATER CONTACT SURFACE DOES NOT MATCH CORRECTLY WITH THE ENGINE BLOCK AS INTENDED. THE BLOCK HEATER COULD COME LOOSE FROM THE ENGINE BLOCK, AND IF BEING USED, COULD POSSIBLY OVERHEAT CAUSING DAMAGE IF IT COMES IN CONTACT WITH OTHER ENGINE COMPARTMENT COMPONENTS.

Risk: ENGINE COMPARTMENT DAMAGE COULD OCCUR INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL INSPECT THE BLOCK HEATER AND SECURE THE BOLTS USED TO INSTALL THE HEATER. IN SOME CASES, THE SURFACE TOLERANCES MAY BE SO INAPPROPRIATE THAT THE HEATER WOULD NEED TO BE REPLACED WITH A HEATER OF A MODIFIED DESIGN.