2016 Chevrolet Malibu problems

“The contact owns a 2016 Chevrolet Malibu. The contact stated that while driving at 61 MPH, the vehicle unexpectedly began idling roughly. The contact stated that a loud noise was heard coming from the vehicle, and the cooling fan cycled on and off. The vehicle was taken to a service center, where it was found overheating. The cause of the failure could not be determined initially; however, the mechanic stated the failure was a known issue requiring a special diagnostic tool. Diagnosis revealed three piston rings leaking at 5 percent and the fourth piston ring leaking at 95 percent. The contact was informed that the piston rings could potentially be repaired if the necessary remedy parts were available for the model year. The failure mileage was approximately 66,000.”

““Steering assist is reduced, drive with care” is showing up for a couple second and disappearing. When that happens my car seems to shut off and the steering wheel stiffens and pull to either the left of right side. All this happens while driving. After the 3rd time of it happening within 10min, my gas fuel level dropped but when back up to the “original” level”

“My car will rev up to 4000 rpm’s and my car will not go about 20 mph. My cruise stopped working after my car went into reduce engine power. The dealership said they fixed all issues but was back to doing the high rev within a week. It started this week telling me to shift to park even though my car was in park. The shift to park cable has been replaced twice now. I have been dealing with this since July of 2025. My car has been in the shop more times than I can count.”

“I am reporting a recurring safety defect related to GM’s known “Shift to Park” issue. My vehicle displays a “Shift to Park” warning even when the vehicle is already in park, preventing the car from shutting off properly and creating a safety risk. This issue has been widely reported and associated with GM recalls and service bulletins. GM previously repaired this issue once while my vehicle was under warranty, acknowledging it as a known defect. The same defect has now reoccurred after the warranty period expired. GM is refusing to repair it again, despite the issue being recall-related and tied to a known defective design rather than wear and tear. This defect affects safe vehicle operation, risks battery drain, rollaway hazards, and driver distraction. I believe this is an unresolved safety defect that should be covered regardless of warranty status.”

“On December 16, 2025 the check engine light and service stabiltrek warning light appeared on my 2016 Chevy Malibu Hybrid. On December 17, 2015 I took the car the Capital Cheverolet service dept who has been servicing my car regularly for the past five years. They performed a complete diagnostics on my car that determined I need to "replace the EBCM with brake pressure modulator valve" and said it would cost over $2800.00. Upon further research I discovered that the same make model and year was recalled under recall #39440. I also learned the my VIN number was not included in this recall. This is a safety defect that has rendered my car not drivable until I get it fixed. As a senior citizen on a fixed income I am unable to fixed. I would like to know why was my car not included in the recall and if its possible to get it on the recall list so it can be fixed.”

“The contact owns a 2016 Chevrolet Malibu. The contact stated that upon depression of the brake pedal, the brake pedal made an abnormal grinding sound and became stiff. The check engine warning light was illuminated. The contact's husband replaced the brake sensor; however, the failure recurred several days later. The contact related the failure to NHTSA Campaign Number: 16V272000 (Electronic Stability Control). The dealer was notified of the failure and informed the contact that the VIN was not included in the recall. The contact was provided an estimate for a diagnostic test and was referred to the manufacturer for assistance. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The vehicle was not repaired. The failure mileage was approximately 120,000.”