2016 Chevrolet Volt power train problems

“I have a 2016 Chevy volt. It had to be towed to a Chevy dealership because it will not drive. The BECM module has failed, as is apparently the case with so many volt owners. GM, as a result of lawsuits about this car, extended the warrantee to fix the issue, but my vin number is not included in the case. The gar is a brick, and there is no way to fix it now. GM doen't even replace these batteries any more, and most often just buys back the bad vehicles. I still owe 9k on this car and it is useless now. I need help. These are the codes is is throwing. B101D P1EOO P1EAC POAFA B3111 U3001 U2401 U2603 U2604 U2605 U2606 U2617 U2618 U2619 U2620 U2621 U2622 U2623 U2624 P1FD1 P1FD2 P1FD3 P1FD4”

“While I driving in the past week, a warning that "propulsion power reduced" appeared on my dashboard several times. The last time that I had driven the car, the heater would not turn off, and the smell of burnt rubber filled the car and then dissipated soon after. The car would only run in it's gas engine mode, and not switch over to electric mode, as it usually would. The next morning, the car would not start. The dash board would light up as if the car started, but when I shifted into drive, a warning appeared on the dash, "Shift to park", as it would when the car is not running. I could not start the vehicle. After plugging the vehicle in, a warning appeared on the console stating that "Charging is not available". The car was towed to the dealership. Their diagnosis showed that the Battery Energy Control Module had failed and must be replaced. They later confirmed that an electric cable needed to be replaced that was "corroded", but they could not confirm the cause of the corrosion because the cable was disposed of already. After researching online, I found that GM issued a Special Coverage bulletin: N232432680, citing a common malfunction of the Battery…”

“Driving at 75 MPH on the freeway the power completely cuts off an a message appears on my dash "Propulsion Power is Reduced" - Pressing the gas barely gives any power, Imagine being in the middle of flowing traffic doing 75 mph to close to 20 mph. Research shows me this is a KNOWN issue with GM and the problem is with the BECM control module. There is also the issue of the EGR valve which apparently is tied into the BECM. I brought to the Chevy dealer and they said the BECM NEEDS to be replace ASAP because GM knows this is a dangerous situation and GM extended the warranty on this part to 150,000 miles. My vehicle is at 152,400 miles and they will not cover this. This is a serious issue that should be a recall that forces GM and Chevy to pay for this fix as it is something they have been aware of for years and it is a major accident waiting to happen. Please make them issue a recall for the BECM fix.”

“Vehicle had the Battery Energy Control Module fail at about 87,000 miles. Vehicle will not start and will leave you stranded when this happens. This is a known defect and GM issued a special coverage to extend the warranty for this specific component, but for some reason only applies to a handful of VINs. Mine was not one of them, so I got stuck with a $2500 repair bill. I love the car and am not mad that they are breaking, engineering is hard. I am mad that even after a requirement from the NHTSA, Chevy is refusing to repair a known defect with their vehicles that can leave the owner stranded and is making the owners foot the several thousand-dollar repair bill. This was my first Chevy, and due to the poor way this has been handled, probably my last.”

“The contact owns a 2016 Chevrolet Volt. The contact stated that while starting and driving at an undisclosed speed, the "Reduced Propulsion" message was displayed. Additionally, after parking the vehicle, the "Shift To Park" message was displayed, and the vehicle failed to turn off. The contact pressed the Start/Stop button and then opened and closed the front driver's side door to turn off the vehicle. The vehicle later failed to charge and start as needed. The vehicle was towed to the dealer, where it was determined that the Battery Energy Control Module (BECM) needed to be replaced; however, the part was on backorder. The vehicle was not repaired. The manufacturer was made aware of the failure and a case was opened. The failure mileage was approximately 83,574. The VIN was unavailable.”

“Faulty micro-switch from factory, causes power surge. Flawed microswitch in transaxle shift cable. Incomplete connection of microswitch resulting higher voltage to PCM.(power control module) This irregularity, shows a DTC code reducing power propulsion during movement. The car will loose power & ability to shift. During driving movement. Quite a safety concern. A "shift to park" error displays on driver display screen. An OBD2 scanner will clear code & after a few attempts remain operational. However intermittent & unpredictable when to expect the loss of traction power.”