2016 Chrysler 2 Series service brakes problems

“was driving and pulling in next to garage heard a loud pop and brake pedal when hard and could not stop the car and hit the side of the garage . safty issue is if i was at a higher speed and light turns red would not have been able to stop the car and would have hit another car or person , there was no warning lights on till after the pop when the red brake light came on, and said service eltric brakes it has been looked at by me and it has the same iisues that the dodge dart had for the recall r63 with the brake booster geting oil in it from the vacuum tube assembly have called chrysler and they said it is not and issue but it is a safty issue”

“I believe the brake or something related to the brakes failed. I ran a stop sign, with no evidence of brake marks on the road. I crossed over a highway hit a side walk almost hit a house. The safety of myself and others was at extreme danger. When finally came to a stop I couldn't put my car in Park, or back in drive or shut my car off, i beleive i had no braking or something electrical failed. My car is totaled. The only light on was the airbag light before the accident.”

“2 weeks ago on approximately May 14th I was backing out of my drive way and my brake pedal was hard and I was barely able to stop my car. It takes approximately 3 to 4 car lengths to fully stop at 10 mph. I replaced the brakes and bled the brakes properly but I have come to the conclusion that the brake booster has gone bad. My safety and others is at risk due to the length of time it takes to stop and the lack of stopping power. I am unable to take it to a dealer as it doesn't run at the present time. The abs and park brake lights were on and the dash says to service electronic braking system. I am trying to get this fixed asap as I need transportation to and from work and I am not trying to put my wife or son in any danger.”

“My car stalls when cranking and has shut down before while on the interstate. I think it’s an electrical problem no signs on the dashboard and saying key fob not detected”

“The contact owns a 2016 Chrysler 200. The contact stated that while depressing the brake pedal to start the vehicle, the pedal was hard to depress. Additionally, while driving the vehicle would suddenly stall without warning. The failure had occurred on multiple occasions. The cause of the failure was not yet determined. The local dealer was notified of the failure. The manufacturer was not yet contacted. The failure mileage was 73,000.”

“ON A HIGHWAY WHILE ABOUT TO CROSS AN INTERSECTION THE ENGINE JUST SHUTS OFF WHEN TAKING OFF. THE ENGINE HESITATES AND DIES WITH NO CHECK ENGINE LIGHTS OR ANYTHING. TAKING AWAY POWER STEERING AND MAKING IT HARDER TO STOP DUE TO THE ENGINE NOT RUNNING.”