2022 Ford Bronco power train problems

“My vehicle has had two misfires and the check engine light came on twice. I brought it to quirk ford in Quincy mass and they said ford has not found a solution for this recall which has been years for this recall. My vehicle putters when I start it and has a skunk aroma when I shut it off”

“Clutch pedal went to floor and didn't return. The accumulator on part # MB3Z-7A512-A failed and broke apart causing a complete loss of brake fluid in the clutch hydraulic system rendering the clutch completely inoperable.”

“2022 Ford Bronco 2.7L EcoBoost VIN [XXX] has experienced recurring engine oil pressure failure causing vehicle to enter limp mode limiting speed to 25mph creating an unsafe driving condition. Diagnostic trouble codes P0524 Engine Oil Pressure Too Low and P06DD Engine Oil Pressure Control Stuck Off confirmed. Two failed warranty repair attempts at Lenoir City Ford Lenoir City TN on XXX and XXX. Dealership provided loaner vehicle both times acknowledging vehicle was unsafe to drive. Ford corporate case number XXC is open. Third repair attempt scheduled XXX.””

“While operating the vehicle under load, the vehicle suffered a sudden and severe loss of engine performance, followed immediately by loud metallic banging from the engine bay. The vehicle lost all power and was immediately disabled (LIMP MODE), presenting an imminent highway safety hazard.The Physical Damage: Subsequent mechanical teardown revealed deep vertical cylinder wall scoring, heavy raw fuel residue in the engine oil pan, and a blown head gasket. Relationship to Active Safety Defect: This catastrophic block failure perfectly mirrors the progressive failure profile of NHTSA Campaign 25V455 / Ford Safety Recall 25S75 (Low-Pressure Fuel Pump Failure). Internal component degradation in the fuel tank delivery module dropped fuel pressure to the engine. Under turbo boost, this starvation induced an extreme, instantaneous lean-out condition. The resulting low-speed pre-ignition (LSPI) exploded and shattered the internal piston rings (the metallic banging), leading to mechanical wall gouging, unburnt fuel wash into the lower crankcase, and a secondary blown head gasket. Request for Action: Ford's current VIN parameters for Recall 25S75 have not yet captured my…”

“The Incident: While operating the vehicle under high load, the driver received an explicit "Service Engine Soon" powertrain malfunction alert stating: "The powertrain control module lost communication with the vehicle active grill shutter module for a period of time." Immediately following this warning, the engine experienced a severe loss of power, followed by loud metallic banging from the engine bay. The vehicle stalled completely and lost all motive power, creating an imminent highway safety hazard.The Physical Damage: Subsequent mechanical teardown by the dealership revealed terminal block destruction, including deep vertical cylinder wall scoring, heavy unburnt liquid gasoline residue in the engine oil pan, and a blown head gasket.Relationship to Active Safety Defect: This catastrophic engine failure mirrors the progressive failure profile of NHTSA Campaign 25V455 / Ford Safety Recall 25S75 (Low-Pressure Fuel Pump Failure). In this EcoBoost architecture, the Active Grill Shutter (AGS) module shares critical voltage paths, grounding blocks, and wiring looms with the engine management and fuel delivery systems. The sudden network communication loss is…”

“Differential carrier replacement due to metal contmination being found in differential during oil change and a transmission overhaul due to excessive wear of(clutch container, CDF bushing, forward hub and front support bushings). They also noted a sticking valve in the main control on my 2022 Ford Bronco 2.7L V6 when taken in to dealership to evaluate vehichle under warranty due to ongoing intermittent thump/clunking noise when coming to a stop and accelerating from a stop as well as when backing up from a stop and while driving as well, intermittent loud metal slapping sound at speeds over 60 mph, intermittent jerking of vehichle when cycling through gears, unexpected downshift at high speeds. After differential replacement and transmission overhaul due to excessive wear while under warranty, my vehichle continues to experience the same symptoms and problems and feel this is a safety issue.”