2014 Ford Fusion service brakes problems

“Ford Motor Company, a massive automotive manufacturer, sold a vehicle with a known, systemic defect that can cause a driver to suddenly lose power steering at highway speeds, while simultaneously disabling critical safety systems ABS and AdvanceTrac stability control. The vehicle's dashboard lights up like a Christmas tree, steering suddenly becomes incredibly heavy, and the safety nets designed to prevent a rollover or spin-out turn off at the exact same moment. Lives are absolutely being put at risk. Because Ford has chosen to handle this through expensive, individual part replacements rather than a massive federal recall, the burden of safety has been unfairly shifted onto the consumer. When the PSCM (Power Steering Control Module) lost communication, it simultaneously disabled my ABS and Traction Control systems. This caused a sudden, unexpected loss of critical safety and handling systems while driving, creating an immediate crash hazard. I have already fixed the vehicle, so I must log the failure. Ford’s network architecture turns a single component failure into a massive, vehicle-wide electrical blackout. I've analyzed the underlying mechanics, and it…”

“Sudden Loss of Power Steering Assistance and Simultaneous ABS/AdvanceTrac System Faults I am submitting this complaint to document a serious vehicle safety incident involving my 2014 Ford Fusion SE. The vehicle experienced a loss of communication with the Power Steering Control Module (PSCM), accompanied by faults affecting the ABS and traction/stability control systems. During the incident, the dashboard illuminated multiple warning lights, and the steering suddenly became extremely difficult to operate. The simultaneous loss of power steering assistance and warnings involving critical vehicle safety systems created a serious potential crash hazard, particularly at highway speeds or during an emergency maneuver. Diagnostic scanning with FORScan revealed the following communication-related diagnostic trouble codes: • U0131 — Lost Communication with Power Steering Control Module. • U0121 — Lost Communication with Anti-Lock Brake System (ABS) Module. • U0420 / U0415 — Invalid or implausible data received, as indicated by the recorded codes. I am concerned that an electrical, electronic, or component-level failure involving the power steering system may be…”

“The contact owns a 2014 Ford Fusion. The contact stated that while driving 30 MPH, the vehicle entered limp mode and failed to accelerate as intended. The transmission ran poorly, making it difficult to merge, and the contact expressed concern regarding a potential crash. Following the failure, the hill brake assist turned off. The brake pedal bumper and stop pad fractured, causing the vehicle to enter limp mode. The contact called the dealer and was informed that a diagnostic test was required to determine the cause of the failure. The contact notified the manufacturer of the failure by phone. The failure mileage was approximately 106,000.”

“The brake pedal switch pad was recalled and failed after being fixed and tripped the whole ABS system which caused the whole transmission to not shift and I didn’t have traction. My taillights stayed on 24/7 and I had to disconnect my battery. Ford did nothing”

“The brake pedal switch pad was recalled and failed after being fixed and tripped the whole ABS system which caused the whole transmission to not shift and I didn’t have traction. My taillights stayed on 24/7 and I had to disconnect my battery. Ford did nothing”

“Complaint Description: I am filing a complaint regarding a severe brake assist failure in my 2014 Ford Fusion. The vehicle has experienced a repeated loss of brake assist, resulting in a hard brake pedal and increased stopping distance. Despite multiple visits to the dealership, only the vacuum pump was replaced, and the root cause was intally never fully diagnosed. Full diagnosis is still under dealersip review at Phil Long Ford of Denver. I am concerned that this is part of a larger, incomplete brake system failure. As several brake recalls have recently been fixed inclding replacing leaking brake lines and brake lights. While there are currently known recalls on certain Ford Fusion brake systems (such as brake hoses, brake lights etc), these recalls do not appear to cover critical components such as the vacuum pump, brake booster, hard brake lines, and camshaft. These omissions leave a gap in addressing a potentially life-threatening safety risk. The dealer’s incomplete diagnostic leaves me and others exposed to a dangerous failure. I urge NHTSA to open an investigation into these brake system components to ensure that a comprehensive recall is considered.…”